Menús En Detalle - DAS DSP-4080 Manual De Usuario

DSP-4080
GLOBAL MEM.
Recall a Memory
Recall Input and Crossover Memories or combinations of.
Store a Memory
Store Input and Crossover Memories or combinations of.
Erase a Memory
Erase Input and Crossover Memories or combinations of.
INPUT SECTION
Input Ganging
Gang (link) inputs together so their parameters track.
Input Reset
Start wizard to reset sections of input parameters.
CROSSOVER
Design a Crossover
Set up a new crossover from scratch. This selection starts a wizard to guide through the
process. Also select this to alter the set-up of the current crossover.
Crossover Ganging
Gang (link) outputs together so their parameters track.
INTERFACE
External Interface
Starts a wizard to configure the baud rate, ID and port selection of the remote interface.
Wiser 2400 Setup
Configures wireless interface (if connected).
GPI Interface
Configure the GPI inputs used for closed contact memory recall (hardware option).
SYSTEM
System Status
Displays a series of information screens including software version, temperature,
hardware and firmware versions, date and time. Press NEXT to jump through info.
LCD Contrast
Adjust the viewing angle of the screen.
LED Brightness
Adjust the brightness of all the meters and button LEDs.
Temperature Alarm
Set the threshold for the unit to flash a warning temperature message on the screen.
Wake-up Time
Adjust the time before the audio fades in on start-up – can also be set to keep mutes on
when powered up.
Output Meters Opt'n
Select the monitoring point for the meters – either pre or post mute (so meters can be
set to work even when outputs muted)
Filter Q/Bandwidth
Select the readout units for the 'Q' setting of parametric filters – 'Q' is 1/Bandwidth (in
octaves) – small 'Q' values mean wide response variations.
Delay Time/Dist'nce
Select the readout units for all delay values – either time, or distance in feet or metres.
Clip LED Hold Time
Select the time that the input CLIP LEDs stay illuminated for after an overload has
passed.
Set Date & Time
Adjust the real time clock settings.
SECURITY
Unit Locking
Protect the unit against unauthorised access with a password - please see page 25 for
more details.
AES/EBU
Output Selection
Switch the outputs of the unit to digital. (Inputs are selected via rear panel switch)
AES Status Info.
Information screen showing details of the incoming AES streams (sample rate/lock).
Menús en detalle
Manual de Usuario 39