Publicidad
Idiomas disponibles
Idiomas disponibles
USER MANUAL LM12 LAMP MODULE
SAFETY WARNINGS
•
To prevent short circuits, this product should only be used inside and only in dry spaces.
Do not expose the components to rain or moisture. Do not use the product close to a bath,
swimming pool etc.
•
Do not expose the components of your systems to extremely high temperatures or bright
light sources.
•
Do not open the product: the device contains live parts. The product should only be
repaired or serviced by a qualified repairman.
•
In case of improper usage or if you have opened, altered and repaired the product yourself,
all guarantees expire. Marmitek does not accept responsibility in the case of improper usage
of the product or when the product is used for purposes other than specified. Marmitek
does not accept responsibility for additional damage other than covered by the legal
product responsibility.
•
Adapters: Only connect the adapter to the mains after checking whether the mains voltage
is the same as the values on the identification tags. Never connect an adapter or power cord
when it is damaged. In that case, contact your supplier.
•
Automatic switching devices provide comfort, but can also be dangerous. They can surprise
people or can ignite clothing hanging over an electric heat source. Please be careful and take
appropriate measures to avoid accidents.
How does Marmitek X-10 work?
Marmitek X-10 components use the existing mains wiring to communicate (using Marmitek X-
10 signals). You can build a complete system using the three different kind of components of
the Marmitek X-10 System:
1. Modules:
These components will receive Marmitek X-10 signals and will switch or dim
the attached lamp or appliance.
2. Controllers:
These components will transmit Marmitek X-10 signals and thus will control
the Modules.
3. Transmitters: Wireless components like remotes. The signals of these components will be
received by a controller with transceiver functionality (IRRF 7243, TM13 or
console of a Marmitek Security System). The Transceiver will translate the
signals into Marmitek X-10 signals on the power line.
Addresses
You can select up to 256 addresses by setting two code wheels on the modules. The two code
wheels are dividing the address into a House Code ( A .. P) and a Unit Code (1 .. 16). On
Controllers the House Code is also selectable. When Modules and Controllers are set to the
same House Code they will work together.
The Marmitek X-10 System contains many standardized commands whereby modules set to the
same House Code will respond simultaneously (e.g. All lights on, all off).
Signal Range
Range of Marmitek X-10 signals over the Power Line and how to increase the range.
The Marmitek X-10 System is based on power line communication. The range of the
Marmitek X-10 signals very much depends on the local circumstances. On average the range
is a cable length of 80 meters.
2
© MARMITEK
Publicidad
