Publicidad
Idiomas disponibles
Idiomas disponibles
Authorized KICKER Dealer:
Purchase Date:
Enclosure Model Number:
Enclosure Serial Number:
CHECK THE LOAD
The Solo-Baric L3 subwoofer enclosures are internally wired for a 2 or 4 ohm load at the speaker-wire
connection terminal. Check to see if your amplifi er is optimized to drive this load.
SOLO-BARIC L3 ENCLOSURES
The Solo-Baric-series enclosures combine KICKER's award-winning line of subwoofers with computer-
modeled and human fi ne-tuned enclosures to offer a level of bass performance never before thought
possible from a commercially available, ready-to-install subwoofer system. The VS12L3 enclosure
features a 12 inch Solo-Baric L3 subwoofer, the TS10L3 enclosure features a 10 inch Solo-Baric L3
Subwoofer, and the DS12L3 enclosure features two 12 inch Solo-Baric L3 subwoofers.
Plug your subwoofer speaker wire into
the terminals using the red connector as
positive and the black connector as negative.
Connect the other end of the wire to your
subwoofer amplifi er in accordance with its
owner's manual.
Sound Check: Poor bass response?
Check the system phasing by reversing the
positive and negative speaker connections
on the subwoofer. If the bass improves,
then the subwoofer was out of phase in
reference to the rest of the audio system.
Pro Tip: You're a KICKER amplifi er, a pair of KICKER coaxials and a few cables away from a full system
upgrade that will dominate! KICKER amplifi ers make it easy to upgrade with your existing or stock source
unit. Ask your dealer about KICKER amplifi ers and coaxial speaker upgrades to complete your system!
Note: The use of a subsonic fi lter will signifi cantly increase power handling. The power handling specifi cation in this chart
is calculated using a 25Hz, 24dB/octave subsonic fi lter.
2
2011 L3 Enclosure Rev B.indd 2
2011 L3 Enclosure Rev B.indd 2
SOLO-BARIC L3 SUBWOOFER
ENCLOSURE OWNER'S MANUAL
Models:
DS12L3 / VS12L3 / TS10L3
10/19/2010 4:06:11 PM
10/19/2010 4:06:11 PM
Publicidad
