Publicidad
The CBSW1NA battery charger can charge both Lead acid batteries (WET) and sealed gel batteries (GEL). To select
the type of battery to be charged, press the switch on the front panel of the battery charger (see figure 1).
When the switch is on WET, the charger can charge Lead acid batteries, while if the switch is on GEL, it can charge
sealed gel batteries.
Battery type
selection
switch (1)
Figure 1: selection of the type of battery to be charged.
ELECTRIC FEATURES
1. System input 230V 50Hz, or 240V 50Hz, 100V 60Hz, 115V 60Hz (other input voltages available on request);
2. Charging parameters insensitive to ±10% system voltage variations.
3. ISO isolation transformer, class H
4. Efficiency > 80%.
5. Output ripple at max load below 150mVpp.
6. Accuracy of power and voltage measurements 1%.
The tests of electromagnetic compatibility (EMC) on these devices were carried out in compliance
with the CEI EN55014-1+A2(04/98-06/99) and CEI EN 55014-2(10/98) STANDARD norms, with
the test instructions and conditions as requested by the norms.
As to the immunity the devices are classified as Category II.
BATTERY CHARGER CONFIGURATION
ELECTROMAGNETIC COMPATIBILITY
NORM
EN 55014-1+A2
EN 55014-1
EN 61000– 3-2
EN 61000– 3-3
EN 61000– 4-2
EN 61000– 4-4
EN 61000– 4-5
EN 61000– 4-6
EN 61000– 4-11
R
ESULT
COMPLIANT
COMPLIANT
COMPLIANT
COMPLIANT
COMPLIANT
COMPLIANT
COMPLIANT
COMPLIANT
COMPLIANT
Publicidad
