Descargar Imprimir esta página

Mitsubishi Electric NTXWPH06A112A Serie Manual De Instrucciones página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

P
REPARATION BEFORE OPERATION
Changing temperature units (°F→°C)
Unit is preset with °F.
1.
Press RESET while
the temperature but-
tons are pressed.
• Press RESET gently using a thin instrument.
• To change temperature unit from °C to °F, press RESET.
Setting the installation position
Be sure to set the remote controller in accordance with the installed position of
the indoor unit.
Installation position:
Left:
Distance to objects (wall, cabinet, etc.) is less than 19-11/16 in. (50 cm)
to the left
Center: Distance to objects (wall, cabinet, etc.) is more than 19-11/16 in. (50
cm) to the left and right
Right:
Distance to objects (wall, cabinet, etc.) is less than 19-11/16 in. (50 cm)
to the right
(Left)
(Center)
(Right)
Area
Left
Remote controller
display
1
Hold down
on the remote controller for 2 sec-
onds to enter the position setting mode.
2
Select the target installation position by pressing
(Each press of the
order:)
(Center)
(Right)
3
Press
to complete the position setting.
Note:
The installation position can be set only when all the following conditions are met:
• The remote controller is powered off.
• Weekly timer is not set.
• Weekly timer is not being edited.
Center
Right
displays the positions in
(Left)
En-4
.

Publicidad

loading