Publicidad
Idiomas disponibles
Idiomas disponibles
NOTICE: Dispose of used hydraulic fluid in accordance
with local environmental regulations.
3. When refilling,
ensure the fluid level is
Oil Filler Plug hole. Reinstall the Oil Filler Plug, then
install Hydraulic Unit onto receiver.
Lubrication
A periodic coating of light lubricating oil to pivot points,
axles and hinges will help to prevent rust and assure that
wheels, casters and pump assemblies move freely.
TROUBLESHOOTING
Symptom
Hydraulic Unit will not lift
Hydraulic Unit bleeds off after
lift
Lifting Platform will not lower
after unloading
Poor lift performance
Will not lift to full extension
For a period of one (1) year from date of purchase, SFA Companies will repair or replace, at its option,
without charge, any of its products which fails due to a defect in material or workmanship, or which fails to conform
to any implied warranty not excluded hereby.
Performance of any obligation under this warranty may be obtained by returning the warranted product, freight
prepaid, to SFA Companies Warranty Service Department, 10939 N. Pomona Ave., Kansas City, MO 64153.
Except where such limitations and exclusions are specifically prohibited by applicable law, (1) the
CONSUMER'S SOLE AND EXCLUSIVE REMEDY SHALL BE THE REPAIR OR REPLACEMENT OF DEFECTIVE
PRODUCTS AS DESCRIBED ABOVE, and (2) SFA Companies SHALL NOT BE LIABLE FOR ANY
CONSEQUENTIAL OR INCIDENTAL DAMAGE OR LOSS WHATSOEVER, and (3) THE DURATION OF ANY AND
ALL EXPRESSED AND IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION, ANY WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS LIMITED TO A PERIOD OF ONE (1)
YEAR FROM DATE OF PURCHASE.
Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not
apply to you. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
even with the
Possible Causes
• Release Valve not tightly closed
• Overload condition
• Release Valve not tightly closed
• Overload condition
• Reservoir overfilled
• Linkages binding
• Fluid level low
• Air trapped in system
• Fluid level low
ONE YEAR LIMITED WARRANTY
5
Cleaning
Check the pump piston and Ram occasionally for signs
of rust or corrosion. Clean as needed and wipe with an
oily cloth.
Storage
When lift is not in use, Lift Platform should be stored in
the fully retracted position.
• Ensure Release Valve tightly closed
• Reduce overload condition
• Ensure Release Valve tightly closed
• Reduce overload condition
• Contact Customer Service
• Drain fluid to proper level
• Clean and lubricate moving parts
• Ensure proper fluid level
• Follow Bleeding/Venting Trapped Air
procedure, pg. 4
• Ensure proper fluid level
Corrective Action
Publicidad
