Publicidad
Idiomas disponibles
Idiomas disponibles
ELIMINATING THE ARM / DISARM CHIRPS:
The normal arming and disarming confirmation "chirps" can easily be turned on and
off using the valet toggle switch. To do this...
1. The valet switch must be in "off" position.
2. Turn the ignition key on, and then off.
3. Within 10 seconds of turning the ignition key off, move the valet toggle switch
to the on-off-on-off-on-then off.
4a. If, before proceeding with step 1, the chirps were on, then you will hear 2 chirps
to indicate that the chirps have been turned off.
4b. If, before proceeding with step 1, the chirps were off, then you will hear 1 chirp
to indicate that the chirps have been turned on.
5. Whenever power to the system is disconnected (for repair or service of the
vehicle), the chirps will be active when power is re-connected. To turn the chirps
off, simply execute 1-3 above.
Note: Whenever the chrips are by-passed, the 3 chirp defect and 4 chirp intrusion
indicator will always operate. This feature will always warn you if there is a defective
sensor during the arming sequence or if the vehicle had been tampered with in your
absence, even if the normal arming and disarming chirps have been turn off.
REMOTE PANIC OPERATION (CHANNEL 1):
The arming button on your keychain transmitter also functions as a "panic" switch
for instant activation of the alarm in emergency situations. To use the remote panic
switch;
1. Press and hold the arming button on the keychain transmitter for 3 seconds or
more. The alarm will immediately sound.
2. To stop the alarm, press and release the arming button on the keychain
transmitter. If the button is not pressed, the alarm will automatically stop after
30 seconds.
WARNING! Excessive pressure on the transmitter buttons will damage the internal
components on the circuit board. All that is required is a light push to the button.
TRUNK RELEASE (CHANNEL 2):
This security system has an additional feature that can be wired to a number of
different optional accessories. Some of the more common uses for this "channel"
are:
Remote Trunk Release - available for any vehicle with factory installed
electronic push-button trunk release.
Remote Car Starter - available for most automatic transmission, fuel injected
vehicles.
Remote Window Roll Up - available for most vehicles equipped with power
windows.
To activate the optional accessory:
1. Press and hold the smaller button on the keychain transmitter for approximately
3 seconds.
NOTE: This feature will not operate when the vehicle's ignition key is turned "ON".
Page 4
Publicidad
