Perel AC008 Manual Del Usuario página 6

4. Description
Refer to the illustrations on page 2 of this manual.
1 power plug
2 mains cable
5. Operation
5.1 Before Use
5.2 Connection
1. Connect the charger to the battery.
2. Connect the power cable of the battery charger to the mains.
The LED will light yellow and the charging begins. If the LED
flashes yellow, check the battery and/or connection.
3. When the battery is fully charged, the LED will turn green.
4. Stop the charging at any time by disconnecting the charger from
the mains.
The LED will turn off in case of wrong connection, reverse connection
or a short-circuit.
V. 01 – 21/08/2017
WARNING
 Before connecting the battery
charger, read the operating
instructions carefully.
 In addition, observe the vehicle
manufacturer's instructions for a
permanently connected battery.
Turn off the ignition.
 Clean the battery terminals.
Ensure that your eyes do not
come in contact with the dirt in
the process.
 Ensure sufficient ventilation.
AC008
3
4
6
charging cable
clamp
©Velleman nv