Bestron ACM801 Manual Del Usuario página 20

OPERATION - Before first use
Clean the appliance a couple of times by filling it with water only. Please observe the
following instructions. Dispose of the water after use.
OPERATION - Making coffee
1. Place the appliance on a flat and steddy surface. Connect the appliance to the wall socket. Make sure
the On/Off switch is set to 'O' (pilot light is extinguished).
2. Open the filter cover. Pour sufficient water into the reservoir (not less than 2 cups and not more than
12 cups, as shown on the water-level indicator).
3. This coffee maker is supplied with a permanent filter, no more paper filters needed. But if you prefer,
you can also fit a paper filter (1 x 4) in the filter holder. Fill the filter with the required amount of ground
coffee (the customary quantity is 1 level scoop for each cup).
4. Close the filter cover.
5. Place the glass pot on the hotplate.
6. Switch on the appliance (On/off switch in the '1' position: the pilot light illuminates). The coffee will now
be prepared.
7. The pause-and-serve function enables you to pour a cup of coffee before the coffee maker has finished.
Replace the carafe quickly, to prevent the filter from overflowing.
• The hot plate keeps the coffee warm for another 30 minutes before it switches off automatically.
The indicator light goes off.
• If you want to make coffee again, please reset the appliance first by manually switching to 0 and
then to 1. The indicator light goes on. But let the appliance cool down for approx. 10 minutes first.
• In case you are finished making coffee, please turn off the appliance by manually switching to 0.
The indicator light goes off.
CLEANING AND MAINTENANCE
1. Switch off the appliance (On/off switch in the 'O' position: the pilot light
extinguishes).
2. Remove the plug from the wall socket, and if necessary allow the appliance to cool.
3. Dispose of the paper filter, where relevant. Remove the permanent filter from the casing, and clean
it under running water. Unlock the filter holder by pulling up the handle (see figure 2). Remove the
filter holder from the casing, and clean it under running water also. Place the filter holder back into the
casing and push the handle down to lock the filter holder. When refitting the filter holder make sure that
the non-drip nozzle projects through the opening in the filter casing.
20
User's instructions
Figure 2
Removing te filter holder