Shindaiwa SP53BPE Manual De Uso Y Cuidado página 5

SPRAYER COMPONENTS & USE INFORMATION, Continued
INSTALLING THE SHOULDER STRAP
The backpack strap is provided with multiple features including
shoulder strap, chest strap, waist belt, lumbar support and back pad
(figure 1). The top of both the shoulder strap and back pad strap
are attached to the top of the tank and are removable. The back pad
strap attaches to the bottom of the tank (figure 2). The back pad is
attached to its strap with velcro and is removable
( figure 3).
The strap from the lumbar support attaches to the base of the
sprayer by sliding buttons into the slot until they snap into place
(Figure 4).
In the event that the sprayer harness (straps) become contaminated
with chemicals, it is recommended to thoroughly wash the straps
with soap & water and allow to dry before using the sprayer.
Figure 2
Back Pad Strap Attachment
WAND/PUMP HANDLE
The pump handle stores
vertically and sets into the
pump handle clip (Figure 1).
The wand is stored in the wand
clip (Figure 2).
FILLING THE SPRAYER
Make sure the filter basket is in place to keep debris from entering the tank.
Determine the amount of mixture needed for your application. Add the proper amount of water to
the tank. Add the proper amount of chemical to the tank (check the chemical label for proper ratio of
chemical). Stir mixture in tank with a clean utensil (like a paint stirrer). The tank will hold the 5-gallon
(20L) capacity plus the chemical.
It is not necessary to completely fill the sprayer tank with each use. You can fill the tank with only the
amount needed for each application.
Always follow the manufacturer's instructions included on their product label.
Back Pad
Strap
Velcro
Attachment
Figure 3
Removable Back Pad
Link
Arm
Pump
Handle Clip
Handle
Figure 1
4E
Lumbar
Support
Removable
Back Pad
Tank Base
Wand
Pump
Shoulder
Strap
Back
Pad
Chest
Strap
Waist
Belt
Figure 1
Strap Assembly
Strap Button
Figure 4
Wand Clip
Pump
Handle
Figure 2