Publicidad
Idiomas disponibles
Idiomas disponibles
24
BOX CONTENT
-
9 x Socket 3/8"10 - 19mm
-
2 x Spark plug wrenches 3/8": 16, 21mm
-
1 x Extensive rod 3/8"x3
-
1 x Universal joint 3/8"
-
1 x Adapter 1/4 "x 3/8"
-
10 x 1/4" Socket: 4-13mm
-
1 x 1/4 "Bit Holder
-
1 x 3/8" Ratchet Wrench
-
1 x 6" Universal Pliers
-
1 x 6" Tip Pliers
-
1 x 6" Curved Tip Pliers
-
1 x Level 9"
•
Carefully remove the product and accessories from the box. Make sure all the items listed in the above list are
present.
•
Inspect the product carefully to make sure it has not been damaged or broken during transport.
•
The product is delivered with a packaging that protects it during transport. Do not throw away the packaging
until the product is complete and functioning properly. Then, recycle the packaging.
ATTENTION: If there are damaged or missing parts, contact the Official Technical Service. Do not
use this product without replacing the damaged or missing part. The use of this product with
damaged or missing parts can cause serious injury to the operator.
ASSEMBLY
BATTERY SCREWDRIVER
INSERTING TIPS
•
Choose the tip that best fits the screw that will be adjusted or loosened. Place the tip inside the mandrel of
the screwdriver and make sure it is completely inside. The cordless screwdriver only takes tips with a 1/4 inch
hexagonal heads. Please note that it does not have the necessary speed to be used as a drill.
CHARGE
•
The internal battery is not fully charged. Before its first use, the battery must be charged between 5 and 8 hours
in order for it to be fully charged. Thereafter, the charges will require between 3 and 5 hours for the battery to
be fully charged.
•
Always recharge the internal battery when tool performance begins to decrease.
•
Charge the internal battery at room temperature, between 50ºF (10ºC) and 95ºF (35ºC).
CHARGER
•
Before using the battery charger, read all instructions and warning marks.
•
Do not replace with any other charger.
•
Do not use the charger if it has been damaged or if it has remained in humid environments.
•
When the battery needs to be charged, a charge of 3 to 5 hours, allows the tool to operate at full power. A
charge indicator light will light up to show that charging is taking place.
-
1 x Flat file 8"
-
1 x Measuring tape 3m
-
6 x Precision screwdrivers
-
50 x Tips
-
6 x Socket 5 - 10mm
-
6 x Drills 1.5, 2, 2.5, 3, 3.5, 4mm
-
8 x Allen keys 1.5 - 6mm
-
1 x Bit Holder
-
7 x Mixed Keys 6 - 15mm
-
1 x Hammer of 300g
-
1 x Screwdriver 3,6V
Publicidad
