Vonyx CDJ450 Double Manual De Instrucciones página 4

12. JOG & SHUTTLE WHEELS
Shuttle: Use the dial to select the scanning direction and speed. The disc is scanned in the forward direction when the
shuttle dial is turned clockwise from the neutral position, in the reverse direction when the shuttle dial is turned
counterclockwise. The scanning speeds up when the shuttle dial is turned faster.
Jog: In pause mode, when turning the jog, the point at which the sound is being produced moves by a number of
frames corresponding to the number of clicks. Clockwise moves the point forwards; counterclockwise backwards. In
play mode, the jog increases or decreases the speed of the track.
13. CUE BUTTON
Pressing the CUE button during play causes a return to the position at which play was started.
14. PLAY / PAUSE BUTTON
By pressing this button, the operation changes from play to pause or from pause to play.
15. DIRECT ACCESS BUTTONS
Press one of the 0-9 buttons to select that one track from the CD.
16. DISPLAY
LCD Display to indicate Track / Numbers / Time / Remain / Pitch / Continue / Single.
17. CD LIGHT
When entering CD work mode, this will light up.
18. SOURCE BUTTON
Press this button to toggle between CD or USB mode.
19. USB PORT
Supports playing tracks by USB. Computer connection by USB eligible only when entered USB work mode.
20. USB LIGHT
When entering USB work mode, this will light up.
21. INPUT TOGGLE SWITCH
Selects which source will be live based on what you have connected to the rear panel input section. In Midi and CD A
position the internal CD units are active.
22. BT
Connect your BT-device to this device and select by SOURCE and INPUT TOGGLE switches.
NOTE: DJ-functions are disabled during BT usage.
23. CUE FOR CHANNEL A-B
Selects which source will be live for CH A and CH B in the mix.
24. INPUT TOGGLE SWITCH
Selects which source will be live based on what you have connected to the rear panel input section. In Midi and CD B
position the internal CD units are active.
25. CHANNEL A & B GAIN CONTROL
Adjusts CH A and CH B level.
26. CUE / MIX / PGM CONTROL
Counter clockwise you will be able to monitor the assigned CUE signal. Slowly turning the control clockwise to the
assigned CUE signal. Slowly turning the control clockwise to middle position allows you to monitor CUE MIX with PGM.
Moving the control clockwise to the right allows you to monitor the PGM output.
27. HIGH FADER A-B
Adjust CH A and CH B equalization of high frequencies.
28. MASTER LEVEL
Adjusts master level output signal.
29. LED METER
Indicates the master output level.
30. MID FADER A-B
Adjust CH A and CH B equalization of mid frequencies.
31. LOW FADER A-B
Adjust CH A and CH B equalization of low frequencies.
32. INPUT FADER
Controls individual source levels for CH A and CH B in the mix.
33. FADER START
Activation allows you to start the CD players from your cross fader.
34. CROSS FADER
Allows for clean segues between the two input channels. Fully left selects channel A, fully right selects channel B. With
the cross fader centered, both assigned channels are live. Use the cross fader for fast and seamless segues from one
selected channel to the other.
35. PITCH CONTROL
Use this fader to increase or decrease the speed of the track.
36. RELOOP
Use this button to start the last saved loop. To finish the loop, press the button once more.
4