Twin-Star International 13QH8007-C242 Manual De Instrucciones página 5

OPERATION INSTRUCTIONS
FUNCTION
POWER
SETTING
TEMPERATURE
ECO MODE
TIMER
A568
ICON DESCRIPTION
The power button supplies power to all of the functions
of the heater. The power button will put the insert in a
standby mode. This will turn off all functions at once but
will hold the settings in the memory. By pressing the
Power button again the unit will turn on at the same
settings.
Pressing and holding the POWER button on the control
panel for 3 seconds will switch between °F and °C.
When pressing the up and down
will enter temperature setting mode.
When in temperature setting mode pressing the
buttons will change the thermostat by 1 °F (1 °C.)
The temperature setting range is between 50 °F - 97 °F
(10 °C - 36 °C).
After 10 seconds without control input the display will exit
temperature setting mode and show the current ambient
temperature.
Pressing this button will turn on/ off the ECO setting.
When enabled ECO Mode will use less energy when
running to maintain warmth.
Press TIMER button will turn on or off timer settings.
There are 10 timer settings and OFF that can be selected.
OFF(00), 30min, 1Hour, 2H, 3H, 4H, 5H, 6H, 7H, 8H, 9H.
Double-digit minute settings, such as: 30 minutes are:
A digital plus a "H" show hours setting, such as:
2 Hours are:
If the timer function was previously set the first press
of the timer button won't change the previous setting.
Pressing the timer button will activate the timer display.
When the timer is active, the display will count down from
60 seconds before shutting off the heater.
5
buttons the display
www.tsicustomerservice.com