Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1
Installing the faucet assembly
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Remove the preassembled lock nut (D) and
washer (C) from the new faucet (A).
□
Before installation, ensure that the ange (B) is
placed on the bottom of the new faucet (A).
□
Place the faucet (A) through the mounting holes
in the sink until the faucet (A) sets on top of the
sink.
□
Secure the faucet (A) to the sink using the
washer (C) and lock nut (D) provided.
NOTE: When you insert the lift rod (N), the lift rod (N) can
go through the faucet (A) and down into the slot of the
washer (C).
B
C
D
A
1
D
2
2
Preparing the pop-up assembly
□
Remove the pop-up stopper (E) and drain
ange (F) from the drain body (I).
I
4
E
F
Publicidad
