GE ADYR22 Manual Del Propietário página 7

Using the Dehumidifier
Removing Collected Water (cont)
NOTES:
• Do not remove the bucket while the dehumidifier is
operating or if it has just stopped operating. This might
cause some water to drip from the drain pan.
• The bucket must be in place and securely seated for
the dehumidifier to operate.
Use a garden hose. Water can be automatically emptied
into a floor drain by attaching a garden water hose (not
included).
1. Unscrew the cover to the hose outlet located at the
rear of the dehumidifier just under the filter.
2. Thread a garden hose (not supplied) onto the nozzle
and ensure it is seated securely. Cut to length and
lead it to the floor drain.
3. Thread a garden hose (not supplied) onto the nozzle
and ensure it is seated securely. Cut to length and
lead it to the floor drain.
4. Replace the bucket in the unit.
NOTE: The bucket must be in place and securely seated
for the dehumidifier to operate. The garden hose must
run down from the dehumidifier to the floor drain.
49-5000764 Rev. 0
Use the internal pump (on some models)
Water can be automatically emptied into a remote
location by attaching the included pump hose.
1. Remove the black rubber drain plug from the garden
hose attachment exposing the hose bar.
2. Connect the included hose to the hose barb. Ensuring
hose fully covers hose bar to prevent leaks.
3. Lead the hose discharge to desired drain location.
4. Make sure pump is activated. To activate the pump,
press and hold the Timer button for 3 seconds. The
Pump On indicator will remain illuminated.
IMPORTANT: Make sure the condensate hose is
properly connected and is not kinked, bent or cracked
as this may cause water to flow onto the floor. Please
ensure the bucket is empty before putting the unit into
pump mode. The bucket must also be fully seated for the
pump to work properly. Do not operate the machine if the
room temperature is 41°F or below.
NOTE: Maximum lift height is 16ft.
7