M-system MF-106 Instrucciones De Uso página 203

REPLACEMENT OF THE ELECTRICAL
FEEDER CABLE
To connect the supply cable:
– Remove the screws securing the
cover "A" on the rear of the cooker.
– Feed the supply cable through the
cable clamp "D". The supply cable
must be of a suitable size for the
current requirements of the appliance;
see the section "FEEDER CABLE
SECTION".
– Connect the phase wires to the
terminal block "B" and the earth wire
to the terminal "PE" (fig. 9.1).
– Take up any slack in the cable and
secure with the cable clamp "D".
– Replace the cover "A".
B
A
Fig. 9.1
PE
N
D
L
FEEDER CABLE SECTION
Type "HO5RR-F"
230 V 3 x 1,5 mm
(*) – Connection possible with plug and outlet
230 V
L
1
(L
Fig. 9.2
2
(*)
N PE
)
2
203