Publicidad
Idiomas disponibles
Idiomas disponibles
9
Initial testing
1. Switch the controller unit on. LED L1 turns on, LED L3 turns on (if the photocells are not obscured and
are correctly aligned).Interrupt the light beam between the photocells with a 50 mm diameter cylindrical
object. The automatic door or gate must stop or reverse direction. The red LED L3 extinguishes.
2. Repeat the procedure, stand near the TX photocell and interrupt the light beam.
3. Repeat the procedure, stand near the RX photocell and interrupt the light beam.
4. When installing two or more pairs of photocells, repeat the same procedure, taking care to check for any
interference between them.
10
Maintenance
Perform scheduled maintenance every 6 months.
Check that the photocells are clean and are working correctly. In particular, keep the outer surfaces of the RX
receiver and the TX transmitter clean.
If any dirt, moisture, insects or other obstructions are found, clean the photocell and repeat the initial testing
procedure.
If any corrosion is found on the printed circuit board, evaluate if it is necessary to replace the board itself.
11
Disposal
This product may only be uninstalled by qualified technical personnel, following suitable procedures for
removing the product correctly and safely. This product consists of numerous different materials.
Some of these materials may be recycled, while others must be disposed of correctly at the specific
recycling or waste management facilities indicated by local legislation applicable for this category of
product. Do not dispose of this product as domestic refuse. Observe local legislation for differentiated
refuse collection, or hand the product over to the vendor when purchasing an equivalent new product.
Local legislation may envisage severe fines for the incorrect disposal of this product. Warning! some parts of this
product may contain substances that are harmful to the environment or dangerous and which may cause
damage to the environment or health risks if disposed of incorrectly.
12
Declaration of Conformity
I the undersigned, as acting legal representative of the manufacturer:
Roger Technology
Via Botticelli 8, 31021 Bonisiolo di Mogliano V.to (TV)
hereby DECLARE that the appliance described hereafter:
Description: Photocell for automatic doors and gates
Model: G90/F4ESI
Is conformant with the legal requisites of the following directives:
• 2014/30/CEE
• 2014/35/EU
• 2011/65/EU
and that all the standards and/or technical requirements indicated as follows have been applied:
EN 61000-6-3; EN 61000-6-2
Last two figures of year in which marking was applied | 17.
Place: Mogliano V.to
Date: 10-05-2017
10
Signature
Publicidad
