Toolland TM81008 Manual Del Usuario página 5

5. Overview
Refer to the illustrations on page 2 of this manual.
1 on-off switch
2 function shift lever
3 function selector
6. Operation
6.1 Auxiliary Handle
The auxiliary handle can be mounted on the left or the right side of the chuck. Mount the handle at the flange
behind the chuck and fix it by turning the grip of the handle clockwise in the desired position.
Depending on the working method, the auxiliary handle can be adjusted in different positions.
This device should be used with both hands only! Do not use the device if the
6.2 Inserting or Removing a Drill/Chisel
Accessories can be very hot after use. Do not touch them with bare hands!
The locking sleeve is used to assembly and remove the drill and chisel.
Inserting
1. Pull back and hold the locking sleeve.
2. Insert the accessory in the SDS chuck while turning and pushing it until it engages.
3. Pull the accessory to check that it is locked correctly.
The accessory requires freedom of movement, which causes eccentricity when the device is off-load.
However, the accessory automatically centres itself during operation without affecting the drilling precision.
Removing
1. Pull back and hold the locking sleeve.
2. Turn and pull the accessory, then remove it from the SDS chuck.
6.3 Switching On and Off
Keep the on-off switch pressed to start the device and to operate. Release to switch it off.
6.4 Using the Hammer/Drill Switch
V. 01 – 07/07/2016
TM81008
WARNING
auxiliary handle is missing or damaged.
WARNING
Hammer/drill mode:
To drill in masonry, concrete and natural stone.
Do not use the hammer/drill mode for ceramic tiles
or other materials not able to withstand impact
energy.
Hammer mode:
To drill in masonry, concrete and natural stone.
5
4 chuck with locking sleeve
5 auxiliary handle
6 oil compartment
©Velleman nv