Publicidad
Idiomas disponibles
Idiomas disponibles
Indication lamp
1
010867
Running the tool allows the indication lamp to show the
battery cartridge capacity status.
Indication lamp
The lamp blinks in red
The lamp lights up inred.
(Note 1)
The lamp lights up in red.
(Note 1)
Note 1: The time at which the indication lamp lights up varies by the temperature
010970
Adjusting the shearing height
2
010871
Changing the position of holding the change lever allows
three-stepped setting for sheared grass height (10 mm,
15 mm, 25 mm).
To change setting, tilt the change lever for the base frame
position and with the change lever tilted move it up or
down along the tool surface until the protrusion on base
frame fits in one of the holes in the tool and release it.
1. Indication lamp
This indicates the appropriate
time to replace the battery
cartridge when the battery
power becomes low.
This function works when the
battery power is almost used
up. At this time, tool stops
immediately
Autostop due to overload
around the work area and the battery cartridge conditions.
1. Change lever
1
2. Protrusion on
base frame
3. Base frame
3
When the tool is also overloaded and has stopped during
operation, the lamp lights up in red.
Refer to the following table for the status and action to be
taken for the indication lamp.
Status
Recharge the battery cartridge
as soon as possible
Recharge the battery cartridge.
Turn off the tool.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing blade cover
CAUTION:
Be careful not to contact the shear blade when
•
installing or removing the blade cover. Contacting
the shear blade may cause personal injuries.
8
Action to be taken
Publicidad
