Publicidad
Idiomas disponibles
Idiomas disponibles
EN
c)
The device is not designed to be handled by persons
(including children) with limited mental and sensory
functions or persons lacking relevant experience
and/ or knowledge unless they are supervised by
a person responsible for their safety or they have
received instructions on how to operate the device.
d)
When working with the device, use common sense
and stay alert. Temporary loss of concentration
whilst using the device may lead to serious injuries.
e)
Use personal protection equipment as required
for working with the device, specified in section 1
(Legend).
f)
The use of correct, approved personal protection
equipment reduces the risk of suffering an injury.
g)
Do not overestimate your abilities. When using the
device keep your balance and remain stable at all
times. This will ensure better control over the device
in unexpected situations.
h)
The placement of the ladder can be changed only
when its user is standing at its base. It is forbidden to
change the ladder position when standing at height
by holding it by the upper part of its frame.
i)
It is necessary to check for any electrical hazards
within the work area, such as aerial power lines or
other electric devices.
j)
It is not recommended to remain on the ladder for
extended periods - regular breaks should be taken at
work (tiredness contributes to hazard).
k)
It is forbidden to wear inappropriate footwear while
working on the ladder.
2.3. SAFE DEVICE USE
a)
Maintain the device in a good technical state. Before
each use check for general damage and especially
check for cracked parts or elements and for any other
conditions which may impact the safe operation of
the device. If damage is discovered, hand over the
device for repair before use.
b)
Clean the device regularly to avoid a durable
encrustation of dirt.
c)
The load carried when walking onto the ladder
should be light and easy to handle.
d)
The ladder should not be used during strong wind
and other unfavourable weather conditions.
e)
It is forbidden to exceed the maximum load capacity
of the ladder.
f)
It is advised against standing under or passing under
the ladder while it is used.
g)
When working on the ladder, the user should be
located between the side members and stand with
both feet on one rung. It is forbidden to lean while
standing on the ladder.
h)
When working on the ladder, one should not use any
tools that may constitute hazard.
i)
A combination of multiple ladders should not be
used in order to increase height.
j)
The ladders are intended for performance of light
and short-term works only.
k)
When working on electric devices, only ladders that
do not conduct electricity should be used.
l)
It is forbidden for children to play on the ladder.
m)
It is necessary to hold the ladder tight while walking
onto it and off it.
n)
It is necessary to avoid excess side load, e.g. when
drilling holes in bricks or concrete.
8
o)
The tools used while working on the ladder have to
be light and convenient to use.
p)
When working on the ladder it is necessary to hold it
or, if possible, apply other safety measures.
q)
If the ladder is transported on a cart or in a truck, it is
necessary to make sure whether it is placed properly
in order to prevent damage to it.
r)
Prior to the first use it is necessary to check
whether the ladder is undamaged and evaluate the
functioning of each of its elements.
s)
It is necessary to make sure that the ladder is
appropriate for the use intended.
t)
It is necessary to remove any soiling from the ladder,
e.g. fresh paint, mud, oil or snow.
u)
Prior to using the ladder at the work area it is
necessary to perform a risk assessment compliant
with regulations valid at the user's country.
v)
The ladder has to stand on all its feet, not on rungs
or steps.
w)
It is forbidden to place the ladder on a slippery
ground (such as ice, shiny surfaces or hard and very
soiled surfaces) unless appropriate measures are
applied in order to prevent the ladder from slipping
or to clean the soiled surfaces sufficiently.
x)
The surface on which the ladder is placed has to be
horizontal and even.
y)
The ladder should be placed in a correct position,
fully unfolded and locked.
z)
It is forbidden to walk onto and off the ladder with
one's back to the ladder rungs.
aa)
It is forbidden to use the ladder as a catwalk.
bb)
The length of the ladder should be adjusted to the
work performed.
cc)
It is forbidden to walk off the ladder in order to reach
another location at height while not being equipped
with additional safety measures, such as a system of
ropes or special stabilising devices.
dd)
Prior to every use of the ladder it is necessary to
inspect it visually for damage and check whether it
is fit for safe use.
ee)
It is forbidden to use the ladder when damaged.
ff)
Prior to using the ladder it is necessary to make sure
that the devices protecting against unfolding are
locked.
gg)
It is forbidden to interfere with the structure of
the device in order to change its parameters or
construction.
ATTENTION! Despite the safe design of the device
and its protection facilities and despite the use of
additional elements protecting the operator, there is
still a slight risk of an accident or injury when using
the device. When using the device stay alert and use
common sense.
3. USE GUIDELINES
The devices is intended for entering minor heights for a brief
period while performing light works.
The user is liable for any damage resulting from
nonintended use of the device.
Rev. 04.09.2021
3.1. DEVICE DESCRIPTION
MSW-AT3PLUS
3
4
2
2
1
MSW-AT4PLUS
3
4
2
2
2
1
1.
Side members
2.
Rung
3.
Platform
4.
Lock
3.2. PREPARING FOR USE/ DEVICE USE
Ladder deployment:
•
Spread the side members until the platform rests
against the lock.
•
Place the ladder.
•
The ladder is ready to be used.
Rev. 04.09.2021
EN
Prior to using the ladder:
•
check whether the side members / feet are not
deflected, bent, twisted, dented, cracked, corroded
or decayed,
•
check whether the side members / feet are in good
condition around the points of fixation to other
elements
•
check whether the fixing elements (standard rivets,
bolts or nuts) are not missing, loose or corroded
•
check whether no rungs / steps are missing and
whether they are not loose, excessively worn,
corroded or damaged,
•
check whether the hinges between the front and rear
part are not damaged, loose or corroded,
•
make sure that the lock remains horizontal and that
the rear railings and corners are not missing, bent,
loose, corroded or damaged,
•
check whether no rung hooks are missing, damaged,
loose or corroded and whether they couple properly
on the rungs,
•
make sure that the control brakes are not missing,
damaged, loose or corroded and that they couple
properly on the side member,
•
make sure that the legs / ladder end caps are not
missing, loose, excessively worn, corroded or
damaged,
•
make sure that the whole ladder is free from any
soiling (e.g. dirt, mud, oil or lubricant)
•
check whether the locking clamps (if included) are
undamaged, free of corrosion and functioning
properly,
•
check whether the platform (if included) has no parts
or fastenings missing and whether it is undamaged
and free of corrosion.
3.3. CLEANING AND MAINTENANCE
a)
Use cleaners without corrosive substances to clean
each surface.
b)
After cleaning the device, all parts should be dried
before reusing it.
c)
Store the unit in a dry, cool place, free from moisture
and direct exposure to sunlight.
d)
Regular inspections of the device must be carried out
in terms of its technical efficiency and any damages
e)
Any repairs and maintenance can be carried out by
well-qualified personal only and in compliance with
the manufacturer's instructions.
The ladder should be stored:
•
in a position that allows maintaining is straight and
even structure,
•
at a place where it cannot be damaged by vehicles,
heavy items or contamination,
•
at a place where it does not cause any hazard of
tripping over and is not a hindrance,
•
securely, so that it is not used for any criminal
purposes,
•
in such a manner that it is secured against being
climbed on.
9
Publicidad
