Publicidad
Adjust the depth of the mounting rails
The mounting rails come preinstalled in the enclosure. Both the front and back sets
of mounting rails can be adjusted independently in 3/4 inch (20 mm) increments to
accommodate different sizes of equipment.
Warning! Do not attempt to adjust the mounting rails when equipment is installed in
the enclosure. Remove the equipment first before you adjust the mounting rails.
1. Each of the mounting rails is connected to the enclosure with a screw and cage nut
in the upper and lower corners of the mounting rail. Use a Phillips type screwdriver
to remove the screws and cage nuts from the mounting rails.
2. Install the cage nuts at the desired depth.
3. Slide the mounting rail to the depth of the cage nuts and use a Phillips type
screwdriver to install and tighten the screws that you removed in step 1. (figure 7)
figure 7
Instruction manual
10
Publicidad
