Publicidad
Idiomas disponibles
Idiomas disponibles
70
INSTALLATION OF THE SEMIAUTOMATIC REEL
1.
Place the inner bracket on the shaft and rotate it until the holes in the shaft and bracket
match. When they match, fix them with the aid of the enclosed L-shaped wrench (1).
2.
Screw the semi-automatic reel manually to the axle in an anti-clockwise direction.
SEMI-AUTOMATIC LOADING OF THE REEL
1.
Remove the lawn mowing carriage from the drive shaft by turning clockwise. To prevent the drive shaft from
rotating together with the reel, lock them by securing an L-shaped wrench (enclosed) through the holes (1).
2.
Place the lawn mower head (A) on a solid surface, then press down and turn the damper (B) clockwise to the
right until the holes in the mowing line are aligned (C) and you can see through the head.
3.
Insert the new string (D) through the lawn mower head so that the lengths of string on each side of the
head are the same.
4.
Hold the lawn mower head firmly, then turn the damper clockwise to roll it into the cutting line. Stop
winding when there is approximately 50 mm (2") of cutting line outside the head.
5.
Install Lawn Mower Head
B
A
USE OF SEMI-AUTOMATIC REEL
•
Use nylon thread to cut grass, grass, weeds and small woody plants.
C
1
D
Publicidad
