Publicidad
Idiomas disponibles
Idiomas disponibles
76
BLADE
The blades should be checked regularly. Blunt blades will reduce the working performance and cause damage to the
machine.
Sharpen each end of the blade and make sure the bottom corner is rounded.
Do not cool the blade with water as it may crack.
GEARBOX
Grease the gearbox every 25 hours of use. Remove the cutting pads to remove the accumulated grease.
TROUBLESHOOTING
The table includes some of the most common problems, their causes and remedies.
PROBLEM
• Incorrect fuel.
• Fuel filter is clogged.
• Carburetor adjustment screw out of
Ignition
normal range.
failure
• Spark plug is dirty / electrode gap not
correct.
• Spark plug disconnected.
• Incorrect or stagnant fuel.
• Carburetor adjustment screw out of
Engine starts
normal range.
but stops /
• Coal accumulates in muffler, cylinder
is difficult to
(exhaust port).
restart
• Dust block in air filter.
• Dust block on cylinder fins, fan cover.
Motor starts
but does
• Square or striated transmissions are not
not transmit
well inserted into each other.
motion to the
• The cutting tool is not properly installed.
cutting tool
NOTE: If you are unable to resolve the problem, please contact the Official Technical Service.
TRANSPORTATION AND STORAGE
•
Allow the equipment to cool completely before transporting or storing.
•
Avoid a location exposed to sunlight when placing the machine in a vehicle. If the machine is left in a locked
vehicle for many hours, high temperatures inside the vehicle can cause the fuel to evaporate and cause a possible
explosion.
•
To prevent fuel loss during transport, the product should be secured in its normal operating position and with
the fuel cap closed.
•
Always store the product in a clean, safe, dry place with temperatures between 0º and 45ºC.
POSSIBLE CAUSE
SOLUTION
• Remove and use the correct fuel.
• Clean fuel filter.
• Adjust the carburetor adjustment screw to
normal range.
• Clean/dry spark plug properly (distance
0.6-0.7mm).
• Retighten the spark plug.
• Remove and use correct fuel.
• Adjust the carburetor adjustment screw to
normal range.
• Clean the muffler immediately.
• Wash the air filter.
• Clean the cylinder fins, fan cover.
• Check that the transmissions are of the
same type and are correctly fitted.
• Check that the accessories are correctly
installed
Publicidad
