Publicidad
Idiomas disponibles
Idiomas disponibles
Cutting Height Adjustment
WARNING
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious injury.
• Stop the engine and wait for all the moving parts to
stop.
• Do not put your fingers under the housing when
adjusting the cutting height.
·
or it will causing serious injury or death.
WARNING
If the engine has been running, the muffler will be hot
and can severely burn you. Keep away from the hot
muffler.
Adjust the cutting height as desired. Set all four wheels
to the same height.
Note:
To lower the mower, move the cutting height
levers forward; to raise the mower, move them
towards the rear. (Figure 7)
Figure 7
1. Raise the Mower
Note:
Height adjustment. 1"- 3"
Starting the Engine
1.Press the primer three times
2.Lower the Mower
Primer
2. Hold the blade control bar (Figure 8) against the
handle.
3. Hold blade control bar then pull the pull start to start
the mower. (Figure 9)
Note:
If the mower does not start after several attempts,
please contact your authorized service center.
Stopping the Engine
To stop the engine, release the blade control bar (Figure 10)
Important:
When you release the blade control bar, both
the engine and the blade should stop within 3 seconds. If
they do not stop properly, stop using your mower
immediately and contact an authorized service center.
5
Publicidad
