Cleaning and maintenance
Warning!
•
Do not use cleaning solvents or abrasives.
•
Do not clean the inside of the device.
•
Do not attempt to repair the device. If the device
does not operate correctly, replace it with a new
device.
•
Replace the battery immediately when the device
gives a low-battery warning. Only use the batteries
specified in the manual.
•
Clean the outside of the device at least once a month.
Use a vacuum cleaner with brush nozzle to clean the
outside of the device.
Trouble shooting:
DO NOT disconnect battery to quiet an unwanted alarm.
This will remove your protection. Fan the air or open a
window to remove smoke or dust.
Problem
Smoke alarm does not sound
when tested.
Smoke alarm beeps with the
red LED flash about once 40
seconds.
The alarm sounds different
from it is used to. It starts
and stops.
Method of disposal
1: Remove smoke alarm
from bracket. Then check the
battery is properly connect to
battery connector.
2: Replace the unit.
Replace battery, please refer to
"Battery safety" section.
1: This alarm is operating
correctly.
2: Clean smoke alarm. Please
refer to the "maintenance and
cleaning" section.
Technical data
Battery
Battery type
Rated voltage
Recommended batteries
Wi-Fi
Wireless frequency
Wireless transmission current
Wireless distance
Total maximum transmission
power
Frequency range
21
1008
EN 14604:2005/AC:2008
1008-CPR-MC 69265548
DOP: 20210811001
Support
If you need further help or have comments or
suggestions please visit www.nedis.com/support
Contact
NEDIS BV, De Tweeling 28, 5215 MC 's-Hertogenbosch,
the Netherlands
5
English
2x AA, alkaline
1.5 V DC
Energize: E91
Gold Peak Group: GP15A LR6
Raymax: LR6
2.4 GHz
< 450 mA
> 30 m
17 dBm
2.412 – 2.484 MHz
Intended fire safety and
installed in buildings
Essential characteristic 1: Pass
Essential characteristic 2: Pass
Essential characteristic 3: Pass
Essential characteristic 4: Pass
Essential characteristic 5: Pass
Essential characteristic 6: Pass
Essential characteristic 7: Pass
Essential characteristic 8: Pass