Domo DO99503S Manual De Instrucciones página 49

Idiomas disponibles

This cooling unit is not intended for use as a built-in appliance.

Select a place with a strong, level floor.

Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will

cause higher electricity consumption.

Avoid very moist places. Too much moisture in the air will cause frost to from very quickly on the

evaporator, and your refrigerator.

Before connecting your refrigerator to the power supply, check that the voltage stated on the rating

label of your appliance corresponds to the voltage in your home. A different voltage could damage the

appliance.

After installation, leave the fridge-freezer for 24 hours before turning it on. This way the refrigerant

can settle.

Allow the appliance to run empty for 12 hours so the compartment can cool to the appropriate

temperature.

One can level the appliance using adjustable legs. The adjustable legs can be adjusted by screwing

them in or out of the appliance.

The climate class indicates the minimum and maximum ambient temperature for the proper operation

of an appliance. You can find the climate class on the type plate on the back of the appliance.

SN: Subnormal: ambient temperature between 10°C and 32°C

N: Normal: ambient temperature between 16°C and 32°C

ST: Subtropical: ambient temperature between 16°C and 38°C

T: Tropical: ambient temperature between 16°C and 43°C

REMOVE THE DOOR

If the appliance cannot pass through the doorways for installation, the doors can be removed and

replaced afterwards. Follow the procedure below:

Loosen the screws of the hinge cover plate and remove the plate.

www.domo-elektro.be

Lift

Lower

DO99503S