Fagor 3CIV-840 Manual De Instrucciones página 69

DOOR REVERSAL
1. Unplug the appliance before reversing the door opening direction.
2. Remove food from the appliance.
3. Remove caps on the front of the refrigerator body (Fig. 1, Fig 2).
4. Remove the two screws, which attach the upper hinge to the appliance door
(Fig. 3). Take special care and hold the appliance door vertically.
5. Holding the door, swing the upper door hinge away from the door using the
other hand (Fig. 4).
Be especially careful during this step, as the hinge may close and cause injury.
6. Remove the two screws, which attach the lower hinge to the appliance door
(Fig. 5). Take special care and hold the appliance door with the other hand.
7. Holding the door, swing the lower door hinge away from the door using the
other hand, then detach the door from the appliance body (Fig. 6).
8. Remove the two screws , which attach the upper hinge to the body and the two
screws holding the lower hinge to the appliance body (Fig. 7).
9. Screw the upper and lower hinge on the opposite side of the appliance body
using suitable screws (Fig. 8). Upper hinge should be mounted on the other
side of the appliance as the lower hinge. The lower hinge should be mounted
on the other side of the appliance as the upper hinge.
10. With the hinges open, hold the door parallel to the appliance body and screw
the hinges to the door using suitable screws while taking proper care.
11. Make sure that the door is properly aligned with the appliance body (Fig. 9).
INSTALLATION OF THE APPLIANCE
Installation of the appliance should be performed by a qualified installer. The ap-
pliance should be placed in furniture case (Fig. 10). Once the appliance is placed
correctly, adjust the height of the appliance by turning the 4 adjustable feet as
appropriate. If necessary, adjacent appliances should be braced with a bracket
fixed by screws and fitted in furniture (Fig. 11). There is a special strip at the top
of the appliance. Attach it to the underside of the cabinet with appropriate screws
supplied with the assembly kit (Fig. 16). Decorative strip must not block the vents
located in the bottom casing unit, the strip must be cut to size (Fig. 17). The depth
of the bottom casing unit can be adjusted by moving it forwards or backwards.
Once properly adjusted, tighten the mounting screws (located in the openings on
both sides of the casing unit) with a cross-head screwdriver. This will permanently
attach the casing unit (Fig. 18).
69