Descargar Imprimir esta página

SNOWJOE 24V-SS13-TV1 Manual Del Operador página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

Fig. 9
Safety lock switch
On/Off switch
3. To stop the cordless snow shovel, release the On/Off
switch.
Positioning the Auxiliary Handle
1. Loosen the auxiliary handle knob.
2. Move the auxiliary handle to a comfortable working
position (Fig. 10).
3. Tighten the auxiliary handle knob (Fig. 10).
Fig. 10
NOTE: In order to prevent the auxiliary handle from moving
around or sliding on the pole, be sure to tighten securely.
Operating Tips
• Start the cordless snow shovel. Push the shovel forward
at a comfortable rate, yet slow enough to clear the path
completely. The clearing width of the snow shovel and the
depth of snowfall should dictate your forward speed.
• Direct the snow discharge to the right or to the left by
holding the cordless snow shovel at a slight angle.
• To remove snow most efficiently, throw the snow
downwind and slightly overlap each swath.
• If you need to clear snow from a crushed rock or
gravel surface, push down on the handle to keep the
scraper bar clear of any loose material that the rotor
blades could throw.
• This cordless snow shovel cuts a path 13 in. (33 cm) wide
and up to 6 in. (15 cm) deep in one pass.
Maintenance
To order genuine replacement parts or accessories for the
Snow Joe
snowjoe.com or contact the Snow Joe
service center at 1-866-SNOWJOE (1-866-766-9563).
Proper Care for Battery + Charger
m
the charger and disconnect the battery pack from the charger
before performing any maintenance task. Never disassemble
the battery pack or charger. Contact your Snow Joe
Sun Joe
service center for ALL repairs.
Auxiliary handle
Auxiliary handle
knob
Replacing the Auger
m
the battery before performing any maintenance task on your
cordless snow shovel.
11
• When clearing deeper drifts, hold the cordless snow
shovel by the upper and lower handles and use a swinging
or sweeping motion. Remove up to 6 in. (15 cm) of snow
with each pass and repeat as many times as needed.
• Remove the battery after using the cordless snow shovel.
Hang the shovel so it will not be misplaced or damaged.
24V-SS13 cordless snow shovel, please visit
®
WARNING!
To reduce the risk of injury, always unplug
dealer or the Snow Joe
®
1. To reduce the risk of injury and damage, never immerse
your battery pack or charger in liquid or allow any liquid to
flow inside these components.
2. Clean out dust and debris from charger vents and
electrical contacts by blowing with compressed air.
3. Use only mild soap on a damp cloth to clean the battery
pack and charger, keeping away from all electrical
contacts. Certain cleaning agents and solvents are harmful
to plastics and other insulated parts. Some of these
include gasoline, turpentine, lacquer thinner, paint thinner,
chlorinated cleaning solvents, ammonia and household
detergents containing ammonia. Never use flammable
or combustible solvents around battery packs, battery
chargers or tools.
4. The 24V iON+ lithium-ion battery charger has no
serviceable parts.
WARNING!
Make sure to turn off the unit and remove
1. Disassemble the left side cover by removing the five (5)
screws that hold it in place (Fig. 11).
+ Sun Joe
customer
®
®
+
®
+ Sun Joe
customer
®
®

Publicidad

loading

Este manual también es adecuado para:

24v-ss13