STACK-ON PDS-1500-B Instrucciones

PDS-1500-B
Serial #:
IMPORTANT
Record the serial number from the tag on the door
front.
Keep keys in a secure place away from children.
DO NOT STORE KEYS INSIDE SAFE.
Hardware Included:
(2) M6 x 15 mm (5/8" long) Screws
(2) M6 Nylock Nuts
Tools Required:
Drill
in Bladed Flat Head Screwdriver
Phillips Screwdriver
10 mm Wrench
1/4" (7 mm) drill bit
®
Instructions
GETTING STARTED
When you rst receive your safe you will need to
open the door with the key in order to install the
ba eries. Ba eries are included and are located
inside the safe.
To open the door with the key, rst remove the
lock cover from the front of the faceplate using a
thin bladed athead screwdriver as shown. Insert
the key and turn clockwise. Hold the key in the
open position and turn the knob to the right to
open the door.
NOTE: is key has also been provided in case the
ba eries run low. If you lose your key, you may
purchase a replacement key by referencing the serial
number located under the removable lock cover
plate. See section at the bo om of this instruction
regarding replacement keys.
Locate the ba eries inside the safe. Open the
ba ery compartment on the back of the door by
pushing the tab in the direction of the arrow and
install the ba eries.
NOTE: e reset bu on located on the inside
of the door, is covered with a removable cap.
When you use the reset bu on while recording
your ngerprint, remove the cap to access the
bu on. Use a pen tip to push the reset bu on.
Replace the cap securely over the reset bu on
a er recording your ngerprint. Failure to do
so will compromise the safety and security of
the safe.
Lock Cover
1
40634-1510
12