Escalade Sports STIGA T8732 Manual Del Propietário página 9

16. Place Leg Assembly (from previous step) on table top. Be sure that
the offset holes in (#19) legs are closest to the table. See
Figure 9 & Detail H.
17. Attach leg Assembly (from previous step) to Bracket (#20) with Hex
Bolt (#24), Plastic Washer (#38) and Locknut (#34) as shown in
Detail I & Detail J. Tighten the Locknuts (#34) all the way but be
careful not to over tighten as you could bend the Leg (#19).
18. Attach Corner Protectors to Table Top using Screw (#5) as shown in
Detail K & Detail L.
Detail L
shorter distance
Closest to the table
Detail H
19
NOTE:
Prepare an area for the assembly of the second table top half. If necessary, move the first
table top half aside with the aid of a helper. Be sure to place it in a location where it won't be disturbed
or damaged. If setting on its side, be sure to place the bottom edge no less than 12 inches away form
the wall. Also be sure to place carpet or pieces of the shipping carton down to protect table top edges.
If floor is not carpeted, brace table top half with a heavy object to keep it from sliding.
19. Repeat steps 10 through 18 to complete second Table Top Assembly.
Bolt (#24) goes in
the top hole of
Bracket (#20)
24
20
Detail I
9
34
38
24
19
20
Detail J
5
Detail K
Figure 9 Figure 9