delvo DLV02SL-CKE Instrucciones De Uso página 8

4.HOW TO 4.HOW TO OPERATE OPERATE
4.HOW 4.HOW TO TO OPERATE OPERATE
1. Attaching and detaching a bit
Move the holder clamp as shown in the diagram below, and insert the bit.
2. Torque Adjustment
To adjust the bit torque, detach torque adjustment ring cover and vary the amount of screwing-in of
the torque adjustment ring.
Torque adjustment ring
3. Screwing
1) After connecting the screwdriver to the controller, plug into the power source.
Guide for Guide for 5 5 5 5 P P P P plug Guide for Guide for
2) Set the changeover switch at
3) When the set torque has been reached, the clutch shuts off immediately and the motor stops
at the same time. Return the trigger to the original position.
4) Unscrewing
Turn the changeover switch to
4. Use the screwdrivers in combination with the following special controllers
DLC16S : This controller features the speed control.
・
Speed control: Set low speed for small size screw and high speed for larger screws.
・
CAUTION CAUTION CAUTION CAUTION
Implement the operation properly. Insufficiently pressed blade or inadequately pulled lever may
result in a malfunctioned and defective driver, or related work damage.
Holder clamp
plug- - - - in in in in plug plug
5P plug 5P 5P 5P plug plug plug
(forward), and trigger the switch. The bit starts running.
(reverse) and trigger the switch.
7
Torque adjustment ring cover