Safety Instructions - TECshow DI BOX Manual De Usuario

2. SAFETY INSTRUCTIONS

CAUTION!
RISK OF ELECTRIC SHOCK
DO NOT OPEN.
This symbol, wherever used, alerts you to
the presence of un-insulated and danger-
ous voltages within the product enclosure.
These are voltages that may be sufficient to consti-
tute the risk of electric shock or death.
This symbol, wherever used, alerts you
to important operating and maintenance
instructions.
Protective Ground Terminal
AC mains (Alternating Current)
AC mains (Alternating Current)
ON: Denotes the products is turned on.
OFF: Denotes the products is turned off.
Warning
Describes precautions that should be observed to
prevent the possibility of death or injury to the user.
Caution
Describes precautions that should be observed to
prevent damage to the product.
Disposing of this product should not be placed in
municipal waste but rather in a separate collection.
Warning
Power Supply
Ensure that them a inssource voltage (AC outlet)
matches the voltage rating of the product. Failure
to do so could result in damage to the product
and possibly the user. Unplug the product before
electrical storms occur and when unused for long
periods of time to reduce the risk of electric shock
or fire.
External Connection
Always use proper ready-made insulated mains
cabling (power cord). Failure to do so could result in
shock/death or fire. If in doubt, seek advice from a
registered electrician.
Do Not Remove Any Covers
Within the product are areas where high voltages
may present. To reduce the risk of electric shock do
not remove any covers unless the AC mains power
cord is removed. Covers should be removed by
qualified service personnel only.
No user serviceable parts inside.
Fuse
To prevent fire and damage to the product, use only
the recommended fuse type as indicated in this
manual. Do not short-circuit the fuse holder. Before
replacing the fuse, make sure that the product is
OFF and disconnected from AC outlet.
Protective Ground
Before turning the unit ON, make sure that it is con-
nected to Ground. This is to prevent the risk of elec-
tric shock. Never cut internal of external Ground
wires. Like wise, never remove Ground wiring from
the Protective Ground wiring from the Protective
Ground Terminal.
Operating Conditions
Always install in accordance with the manufactur-
er's instructions. To avoid the risk of electric shock
and damage, do not subject this product to any liq-
uid/rain of moisture. Do not use this product when
P. 3
| Tecshow DI Box
English version