Publicidad
Idiomas disponibles
Idiomas disponibles
DIGA.book Seite 16 Donnerstag, 5. Oktober 2006 2:01 14
Machine Elements
1 Air-intake opening/lid with filter mat
2 Cover/port for gas cartridge
3 Trigger
4 Control indicator for charge condition of
battery
5 Battery
6 Battery unlocking button
7 Belt holding bracket
8 Retaining spring
9 Magazine base
10 Magazine
11 Exhaust outlet
12 Tensioning slider
13 Release lever
14 Neck-down sleeve/firing safety
15 Locking latch
16 Thumbwheel for drive depth (DIGA WO..)
Not all of the accessories illustrated or described are included
as standard delivery.
Battery and Charger
Charging the Battery
Prior to the initial starting of operation as well as
after longer periods of non-usage, the battery must
be charged for 24 hours in order to reach its full
capacity.
To remove the battery from the tool, fully press in
both unlocking buttons 6.
Plug the power supply into the power outlet and the
charge connector into the socket of the charger. The
charging procedure begins as soon as the battery is
placed into the charger cradle. During charging, the
battery as well as the charger warm up, which is
normal.
Control Indicators
For control of the charging condition, the charger is
equipped with a red and a green LED indicator:
green LED lights up:
Charger is ready for operation; battery is fully
charged.
red LED lights up:
Charge procedure in progress; battery is being
charged.
red and green LED flash alternately:
Temperature error; battery is too hot and can not
be charged
remove battery and allow to cool
down.
16
All manuals and user guides at all-guides.com
Indicator for Battery Charge Condition
The indicator 4 on the tool is used to gauge the
charge condition of the battery. It lights up red when
the battery must be charged.
Attaching the Metering Valve
For precise metering of the gas mixture required for the
combustion procedure, the supplied metering valve
must be attached onto the gas cartridge. Only this me-
tering valve guarantees a precise dosing of the gas
mixture and thus the resulting impact force.
red and green LED flash at the same time:
Charging is not possible; battery is defective
replace battery.
Gas Cartridge
1. Press the protective cap 17
toward the front and take it off.
17
2. Remove the protective cap.
3. Attach the metering valve 18
onto the nozzle of the gas car-
18
tridge 19 and allow it to
engage in the front groove.
Do not point the outlet open-
19
ing of the metering valve to-
wards face or eyes!
4. Press the rear part of the me-
tering valve downward until it
can be heard to engage
(2 "clicks").
Take off the metering valve 18 before trans-
port and storage and attach it again together
with the gas cartridge.
Publicidad
