Publicidad
Idiomas disponibles
Idiomas disponibles
TO REMOVE BLADE fROM SAW
WARNING:
CUT HAzARD. Turn off and disconnect tool from power source before
making any adjustments or removing or installing attachments or accessories.
WARNING:
Burn hazard. Do not touch the blade
immediately after use. Contact with the blade may result
in personal injury.
1. Rotate blade clamp collar to release position.
2. Remove blade.
TO REMOVE A BROkEN BLADE
If the blade breaks so that the broken piece is caught
inside the clamp, take the following steps to remove the
remainder of the blade from the saw.
1. Rotate blade clamp collar clockwise as
viewed from the back of the saw and hold in
place (figure 4).
2. Turn the saw on its left side as viewed
from the back of the saw (figure 5).
3a. If the blade has broken inside the
clamp, slide a flat object into the opening of
the clamp (figure 6) as far as it can go, then remove the
flat object. This will disengage the pin inside the clamp.
3b. If the blade has broken outside the clamp, slide a
flat object into the opening of the clamp (figure 6) to the
left of the blade as far as it can go, then remove the flat
object. This will disengage the pin inside the clamp.
4. While still holding the clamp collar open and the saw
on its side, face the clamp opening down and shake until
the broken blade falls out.
ORBITAL ACTION SELECTOR - (fIGURE 7 PC85TRSO ONLy)
The PC85TRSO has dual blade motion:
straight reciprocating motion or orbital motion.
Straight reciprocating motion is used for all
metal cutting operations and for wood cutting
applications where finish is more important
than speed. To set the saw for straight
reciprocating motion, turn the selector to the
position marked
Orbital motion is used for fast cutting of wood. To set the saw for orbital action, turn the
selector to the position marked
ADJUSTABLE SHOE - (fIGURE 8 PC85TRSO ONLy)
WARNING:
CUT HAzARD. Blade
breakage may occur if the blade does not
extend past the shoe and the workpiece
during the cut. Increased risk of personal
injury, as well as damage to the shoe and
workpiece may result.
WARNING:
CUT HAzARD. Turn off and
disconnect tool from power source before
making any adjustments or removing or
installing attachments or accessories.
The shoe will adjust to limit the depth of cut. Push the button (shown in figure 8) on
the hand grip and slide the shoe out to the desired depth and release the button.
CAUTION:
CUT HAzARD. To prevent loss of control, never use tool without shoe.
CAUTION:
RISk Of PERSONAL INJURy AND PROPERTy DAMAGE. Ensure the
shoe is locked into position before using tool.
4
5
6
7
8
7
Publicidad
