NightStick INTEGRITAS XPR-5582GX Manual Del Usuario

Instruction Manual
INTEGRITAS™ XPR-5582
US PATENT 9,713,217
Please read these instructions before using your Nightstick XPR-5582. They include important
safety information and operating instructions.
THE XPR-5582 IS APPROVED FOR USE
Bayco Products, Inc.
640 S. Sanden Blvd., Wylie, TX 75098
ID 4003544
INTRINSICALLY SAFE
SECURITE INTRINSEQUE
WARNING: Risk of ignition - Do not open in a hazardous area.
AVERTISSEMENT: Ne pas ouvrir dans une zone dangereuse.
WARNING: Risk of ignition - Do not charge batteries in a hazardous area.
AVERTISSEMENT: Danger d'inflammation - Ne pas charger les piles dans une
zone dangereuse.
WARNINGS - INTRINSICALLY SAFE
y Warning: To prevent ignition of a hazardous atmosphere, do not locate the charger for this product
in the hazardous environment. The charger for this product must be located in an area known to be
non-hazardous ONLY.
y Warning: To prevent ignition of a hazardous atmosphere, do not attempt to charge this product in the
hazardous environment. This task must ONLY be performed in an area known to be non-hazardous.
y Warning: Lithium-ion batteries must be used and charged properly. Improper use can result in
seriousinjury,fi  re,ordeath.
y Warning: Use only the included and approved 5582-BATT rechargeable battery pack from Bayco Products.
y Warning: Do NOT attempt to use any other rechargeable or non-rechargeable batteries with this light.
y Warning: To prevent ignition of a hazardous atmosphere, do not open the lens bezel in the hazardous
environment. This task must ONLY be performed in an area known to be non-hazardous.
y Warning: When exchanging the rechargeable battery pack, use only the approved 5582-BATT
rechargeable battery pack from Bayco Products.
y Warning: To prevent ignition of a hazardous atmosphere, the rechargeable battery pack must only be
exchanged in an area known to be non-hazardous.
y Warning: Do not expose the rechargeable battery pack to water or salt water, or allow the battery
pack to get wet.
y Warning: Do not store the rechargeable battery pack with metallic objects that may cause a short circuit.
y Warning: Substitution of components may impair intrinsic safety.
SPECIAL INSTRUCTIONS FOR INTRINSIC SAFETY
For personal safety, always confi  rm the rating of any known hazardous or potentially hazardous
location where the light is to be used.
INITIAL USE
Warning: To prevent ignition of a hazardous atmosphere, do not attempt to charge this product in the
hazardous environment. This task must ONLY be performed in an area known to be non-hazardous.
FullychargetheXPR-5582beforethefi  rstuse,orifthebatteryisneworhasbeenunusedforseveral
months. The maximum charge time required is approximately 6 hours.
DAILY USE
WARNING: TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, DO NOT ATTEMPT TO
CHARGE THIS PRODUCT IN THE HAZARDOUS ENVIRONMENT. THIS TASK MUST ONLY BE
PERFORMED IN AN AREA KNOWN TO BE NON-HAZARDOUS.
y Use only the supplied Nightstick charger, 5582-BATT rechargeable battery pack and AC or DC
adapter.Forbestperformance,chargethe5582whenthefl  ashlightbeamstartstodim.
y Connect the AC power adapter to the charger. The LED indicator will not be illuminated at this point.
y Withthefl  ashlightfacingforward,slidethe5582intothechargeruntilthecontactssnapintoplace.
y The LED indicator changes to constant red indicating the 5582 is properly inserted into the charger
and is charging. The LED indicator remains red until the battery is fully charged. At full charge, the LED
indicator turns green.
y The total time to fully charge the 5582 varies depending on the remaining charge in the battery pack.
y  T oconfi  rmafullcharge,keepthe5582inthechargerandturniton.TheLEDindicatorwillchangeto
red. Turn off the 5582. If the 5582 is fully charged, the LED indicator will turn green. If not, it remains red
until the charge is completed and the LED indicator turns green. The 5582 will now be fully charged.
REPLACING LITHIUM-ION RECHARGEABLE BATTERY
WARNING: WHEN EXCHANGING THE RECHARGEABLE BATTERY PACK, USE ONLY THE
APPROVED 5582-BATT RECHARGEABLE BATTERY PACK FROM BAYCO PRODUCTS.
XPR-5582
CLASS I DIV 2 GRPS A-D T3
CLASS II & III DIV 2 GRPS F-G T135°C
CLASS I ZONE 2 Group IIC T3
-20ºC ≤ Tamb ≤ +40ºC
3.7V/Cell 5582-BATT
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • USA • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
WARNING: TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, THE RECHARGEABLE
BATTERY PACK MUST ONLY BE EXCHANGED IN AN AREA KNOWN TO BE NON-HAZARDOUS.
y Loosen the screws located on the bottom of the light and remove the plate to expose the battery pack.
y The battery is connected to the light with a wire that has a snap connector. Remove the battery pack
fromthelightbyfi  rstdisconnectingthewiresthatsnaptogether.
y Using only the approved replacement 5582-BATT rechargeable battery pack from Bayco Products,
place the new battery pack into the housing and reconnect the wires.
y Replace the base plate and tighten all the screws. CAUTION: Do NOT overtighten the screws. Doing
so may damage the threads and impact the light's intrinsic safety.
DIRECT WIRING CHARGER BASE INTO A VEHICLE
WARNING: CHARGER INPUT: 12 VDC MAX. MODIFYING A CIGARETTE LIGHTER PLUG-IN DC
ADAPTER CORD WILL VOID YOUR PRODUCT WARRANTY.
12V PASSENGER VEHICLE / LIGHT TRUCK INSTALLATION
Parts needed: 12-Volt Direct Wire Kit (Part # NS-DW12 included)
IMPORTANT: Before attempting to modify your vehicle's wiring, remove the negative battery
clamp and secure it.
y Connect red positive wire (labeled +) of 12-Volt Direct Wire Kit to a positive power source (12VDC),
either directly to the battery for constant charging, or fuse panel for ignition switch-operated power.
y Connect black wire of 12-Volt Direct Wire Kit (labeled -) to a ground wire or chassis ground.
Note: Direct battery connection will provide constant charging for your light but should only be used
in combination with a supplemental vehicle trickle charger / shore power connection. Failure to provide
this supplemental vehicle charging source could result in draining the main vehicle battery.
12V+ COMMERCIAL VEHICLE / APPARATUS INSTALLATION
For commercial vehicles or fi  re apparatus that produce more than 12VDC, the 12-36 Volt
Regulator/Direct Wire Kit is required (Part #NS-DW1236 sold separately).
IMPORTANT: Before attempting to modify your vehicle's wiring, remove the negative battery
clamp and secure it.
y Connect red wire of 12-36 Volt direct-wire adapter to a positive power source (12-36VDC), either
directly to the battery for constant charging, or fuse panel for ignition switch-operated power.
y Connect black wire to a ground wire or chassis ground.
Note: Direct battery connection will provide constant charging for your light but should only be used
in combination with a supplemental vehicle trickle charger / shore power connection. Failure to provide
this supplemental charging source could result in draining the main vehicle battery.
OPERATION
Turn Light On/Off:
Pressandreleasethefl  ashlightswitch.Thelightwillturnoninhighbrightnessmode.Pressand
release to turn off.
Select Brightness Level:
Press and hold the fl  ashlight switch. The light will cycle from high to low and back at a rate of
approximately one mode per second and will continue to cycle while the switch is held down. Release the
switch when the desired brightness level is reached.
Rear Light:
ThereargreenLEDlightstaysonwhilefl  ashlightisinoperationregardlessofmodeselected.
WARRANTY
LIMITED LIFETIME WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in workmanship and materials for
the original purchaser's lifetime. The Limited Lifetime Warranty includes the LEDs, housing and lenses.
Rechargeable batteries, chargers, switches, electronics and included accessories are warranted for a
period of two years with proof of purchase. Normal wear and failures which are caused by accidents,
misuse, abuse, faulty installation and lightning damage are excluded.
We will repair or replace this product should we determine it to be defective. This is the only warranty,
expressedorimplied,includinganywarrantyofmerchantabilityorfi  tnessforaparticularpurpose.
For a complete copy of the warranty, go to www.nightstick.com/nightstick-product-support/warranties.
Retain your receipt for proof of purchase.
INS-XPR-5582-DL-20
08-25-2020