Apex Digital DT504 Manual Del Usuario página 7

Remote Control Battery Installation
Remote Control Battery Installation
Remove the battery compartment cover.
1
Load two fresh "AAA" batteries into the battery compartment.
2
Make sure the batteries are inserted properly, matching polarity
by referring to the symbols "+ -" marked in the battery compartment.
Close the battery compartment cover.
3
• When replacing batteries, replace both of them. Do not mix new and
used batteries together as battery life will be shortened.
Remote Control Operation Range
Point the remote control unit no more than
20 feet from the remote sensor and within
30º from the front of the unit.
• The operating distance may vary depending on
the brightness in the room.
Note:
• Do not point bright lights towards the remote control
signal sensor.
• Do not place objects between the remote control
unit and the remote signal sensor.
• Do not use the remote control unit while operating
other units at the same time.
6
6
Remote Sensor
30º
EN