Greencut PIN660C Manual De Instrucciones página 51

COMMISSIONING
AIR HOSE CONNECTION
1. Connect the air hose to the end of the mobile base. Align the tongue with the groove on the movable base.
Secure by turning counterclockwise.
2. Connect the other end of the air hose to the gun. Align the tab with the slot in the gun. Secure by turning
counterclockwise.
1
3. Unscrew the paint can from the spray gun.
4. Adjust the suction tube properly. It should be possible to spray the contents of the paint can leaving little
paint in the paint can.
SPRAYING
HORIZONTAL AND OVERHEAD OBJECTS
1. Rotate the suction tube inside the container pointing towards the front of the gun.
2. Rotate the suction tube so that it points backwards, as the suction tube must point towards the back of the
spray gun to expel the entire contents.
1
FILLING THE PAINT CAN
1. While filling the can with paint, filter the paint through a piece of nylon stocking or a funnel that incorporates
a filter to remove any lumps or particles. Do not overfill.
2. Screw the canister onto the spray gun making sure it is securely fastened.
CONNECTION
1. Place the spray gun on the mobile stand of the machine base to transport it to the job site.
2. Unwind the connecting cable. Insert the plug into the outlet and turn it on.
3. Remove the spray gun from the gun holder on the mobile base and point it at a piece of cardboard or
newspaper. Switch on the machine with the ON/OFF switch on the mobile base.
NOTE: When the mobile base is connected, air flows continuously from the air cap.
2
2
51
EN