Descargar Imprimir esta página

Greencut ATD200L-SB Manual De Instrucciones página 47

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

BATTERY INSTALLATION
NOTE: If the battery is fully charged, the charger will automatically switch to the maintenance
charging function. In this way, the battery can remain in the charger safely and indefinitely.
ATTENTION: The battery must be charged before the first start.
1.
Press the lock button and remove the battery from the device.
2.
Insert the battery into the charger.
3.
Plug the charger into the power supply unit. The charge status is shown by the indicators on the charger.
4.
Insert the battery pack into the device and make sure that it clicks into place correctly.
BATTERY CONTROL LIGHTS
4 leds on: The battery is full.
1,2 or 3 leds on: The battery has enough energy.
1 led on: The battery is empty. Recharge the battery.
4 leds blinking: The battery is too hot or too cold. Do not use or charge the battery, wait until the battery
temperature is between 4ºC and 40ºC.
CHARGER CONTROL LIGHTS
STATE
RED LED
GREEN LED
ON
OFF
Fast blinking
OFF
Slow blinking
OFF
Fast blinking
Slow blinking
The charger is connected to the mains and is ready for use; there is no
OFF
battery pack in the charger.
Low current safety load
As the battery voltage is less than 15V, the charger is in soft charge mode,
the charging current is less than 0.5A. This can maximise the life of the
battery.
High current safety load
As the battery voltage is above 15V, the charger is in fast charging mode,
the charging current is at 2.3-2.4A.
The battery is charged and ready for use
ON
Action: Remove the battery pack from the charger. Disconnect the charger
from the main supply.
Fault: Loading is no longer possible. The battery may be defective.
OFF
Action: Never charge a defective battery pack. Remove the battery pack
from the charger.
Temperature failure
The battery is too hot or too cold (below 40ºF).
OFF
Action: Remove the battery pack and keep it at room temperature (approx.
68ºF) for 3 hours.
EXPLANATION AND ACTIONS
47
EN

Publicidad

loading

Este manual también es adecuado para:

Atd200l