GE ZSA1202 Instrucciones De Instalación página 16

To use toggle bolts:
Spacing for Toggles More
Than Wall Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
3 Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall to
mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed
flush against the wall and that the plate is properly
centered under the cabinet.
CAUTION
Be careful to avoid pinching
fingers between the back of the mounting plate
and the wall.
Tighten all bolts. Pull the plate away from the wall
4
to help tighten the bolts.
B3 USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and a
hole large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION
Wear safety goggles when
drilling holes in the cabinet bottom.
16
Installation Instructions
Bolt End
B4
ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
1 Remove the three screws that hold the blower
plate to the oven. Slide blower plate from under
its retaining flange. Remove and save the screw
that holds blower motor to oven. Remove the
cover plate installed on the back.
Retaining
Flange
2 Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
BEFORE: Fan Blade
Openings Facing Up
End A
3 Rotate blower unit counterclockwise 180°.
Before Rotation
Back of
Oven
4 Gently remove the wires from the grooves.
Reroute the wires through grooves on other side
of the blower unit.
Before Rerouting
Wires Routed Through
Right Side
Blower
Plate
Blower
Motor Screw
Cover Plate
End B
After Rotation
Back of
Oven
After Rerouting
Wires Routed Through Left
Side
31-7000138 Rev. 0