Publicidad
Idiomas disponibles
Idiomas disponibles
Safety and installation instructions
2
Safety and installation instructions
Please observe the prescribed safety instructions and stipulations
from the vehicle manufacturer and service workshops.
The manufacturer accepts no liability for damage in the following cases:
Faulty assembly or connection
Damage to the product resulting from mechanical influences and excess
voltage
Alterations to the product without express permission from the manu-
facturer
Use for purposes other than those described in the operating manual
NOTICE!
A
To prevent the risk of short circuits, always disconnect the negative
terminal of the vehicle's electrical system before working on it.
If the vehicle has an additional battery, its negative terminal should
also be disconnected.
WARNING!
!
Inadequate supply cable connections could result in short circuits,
which could have as a consequence that:
– Cable fires occur
– The airbag is triggered
– Electronic control devices are damaged
– Electric functions fail (indicators, brake light, horn, ignition,
lights)
Please observe the following instructions:
When working on the following cables, only use insulated cable lugs,
plugs and flat push-on receptacles:
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, earth)
Do not use terminal strips.
The safest type of connection is to solder the ends of the cables together
and then insulate them.
Only use insulated cable terminals, plugs and flat sockets for releasable
connections. Do not use crimp terminals (cable connectors) or terminal
strips.
Use a crimping tool (fig. 1 10, page 2) to connect the cables.
18
MagicComfort MSH200
EN
Publicidad
