ARDES AR4W04P Folleto De Instrucciones página 18

To turn the appliance on put the plug in the socket and position the switch (1) to
"I". The appliance will emit a "beep" sound and the display will show "S" to indicate
stand-by mode.
CONTROL PANEL OPERATION:
-Push On/Off
display will show "- -".Push this button when unit is On to turn it Off; the display
will show "S" (wait 30 seconds until the fan will stop);
-Push speed pushbutton
will show "- -"), minimum power (the display will show "- -" and the indicator light
"I" will be on in the display) or maximum power (the display will show "- -" and the
indicators light "I" and "II" will be on in the display).
-Push Timer pushbutton
off function) from 1 to 12 hours. Each pressing increase 1 hour time. If the timer
off function is activated the indicator light will be on in the display. To deactive
timer off function, push timer button till the display show "0 0".
-Push Timer pushbutton
to set the automatic on from 1 to 12 hours (timer on function). Each pressing
increase 1 hour time. If the timer on function is activated the display shows the
appointment turn-on time and the indicator light will be on in the display. After the
setting time the unit fill turn on automatically.
The default setting temperature is 23°C and the indicator light related to the timer
will turn off in display. To deactive timer on function, push timer button till the
display show "0 0".
- Attention: after timer on, the unit will turn into stand-by mode after 12
hours of continuous work if the temperature and weekly program has
not been set.
REMOTE CONTROL OPERATION:
Batteries
Remote control is supplied with battery inside (CR2025 type, 3V); remove the
transparent sheet from the battery cover before use remote control.
When the battery is over, it must be replaced with the same type.
To remove battery, follow the drawing on the back of remote control.
The On/Off (
control have the same function of the pushbutton in the control panel.
Set the current time and day (if unit is in stand-by mode or working status):
1. Press "SET" pushbutton: the display show "12" as default hour.
2. Press + or - pushbuttons to select the current time (hours).
pushbutton: the appliance will start to work in fan mode and the
repeatedly to select: fan mode only (the display
when unit is on to set the automatic shutdown (timer
when unit is in stand-by mode ("S" on the display)
), speed ( ) and timer ( ) pushbuttons of the remote
18/89