Publicidad
Idiomas disponibles
Idiomas disponibles
7. The inner diameter of the flexible hose, which the butane hose nozzle
is connected, should be 6mm for the house-type gas tubes. The inner
diameter of the flexible hose, which the natural hose nozzle is connected,
should be 15mm.The hose should tightly be fitted to the hose nozzle by
squeezing with a clamp.
8. The hose should be replaced before its last expiry date.
9. The gas bottle diameter shall be max. 300 mm.
10. Caution! Make the oven connection to the gas inlet valve, the hose
length must be short and be sure that there is no leakage. The hose
used should not be longer than 125 cm for safety.
11. RE-INSPECT THE GAS CONNECTION.
12. When placing your oven to its location, ensure that it is at the
counter level. Bring it to the counter level by adjusting the feet if necessary.
DO NOT MAKE GAS HOSE and ELECTRICAL CABLE OF YOUR OVEN GO
THROUGH THE HEATED AREAS, ESPECIALLY THROUGH THE REAR SIDE OF
THE OVEN. DO NOT MOVE GAS CONNECTED OVEN. SINCE THE FORCING
SHALL LOOSEN THE HOSE, GAS LEAKAGE MAY OCCUR.
INSTALLATION OF THE OVEN FEET
In order to install the oven feet;
1. Foot attachment lath is installed on the oven from the bottom of the
oven as shown in (Figure 1). Nuts are centered on these lathes in order to
screw feet (Figure 2). Complete the feet installation process by screwing
the feet to the nuts (Figure 3).
2. You can balance your oven by turning the screwed feet according to
the surface type you are using.
3. If your oven has plastic food as in you can adjust your ovens height
from these feet as turned clockwise or anticlockwise.
Figure 1
GB
Figure 2
9
Figure 3
Publicidad
