Publicidad
Idiomas disponibles
Idiomas disponibles
I
NITIAL SETTING
Auto Channel Scan
If you switch wires (e.g., between antenna and CATV) or if you move the
unit to a diff erent area after the initial setting, or if you recover the DTV
channel you deleted, you will need to perform auto channel scan.
Before you begin:
Make sure if the unit is connected to antenna or cable.
1
Press [SET-UP] to display the main menu.
2
Use [Cursor K/L] to select "CHANNEL SETUP",
then press [ENTER].
or
3
Use [Cursor K/L] to select your desired preset
type, then press [ENTER].
or
• When aerial antenna is connected, select "AUTO
PRESET CH (TV)", "AUTO PRESET CH (DTV)" or "AUTO
PRESET CH (TV/DTV)".
• When connected to CATV, select "AUTO PRESET CH
(CATV)".
• Auto scanning begins.
• When the scanning and memorizing are completed,
the lowest memorized channel will be displayed.
• When you selected "AUTO PRESET CH (TV/DTV)", the
lowest memorized analog channel will be displayed
when the scanning and memorizing are completed.
If there is no analog channel, the lowest memorized
digital channel will be displayed.
12
EN
e.g.) digital TV mode
--- TV SETUP ---
CHANNEL SETUP
V-CHIP SETUP
LANGUAGE
[ENGLISH]
CAPTION
[OFF]
DTV SETUP
e.g.) digital TV mode
--- CHANNEL SETUP ---
ADD/DELETE (DTV)
AUTO PRESET CH (DTV)
AUTO PRESET CH (TV/DTV)
AUTO PRESET CH (CATV)
! CATV takes approx. 50min.
e.g.) digital TV mode
D25
AUTO PRESET CH(DTV)
Note:
• If you connect the cable system directly, contact the CATV
installer.
• If you press [STANDBY-ONy] or [SET-UP] during "AUTO
PRESET CH", the setting will be canceled.
• When no channel can be received by "AUTO PRESET CH",
"NO TV SIGNALS" is displayed on the TV screen.
• Channel setting will be saved even if the power fails.
• If you have Spanish or French menus and need English,
press [SET-UP]. Use [Cursor K/L] to select "IDIOMA" or
"LANGAGE". Press [ENTER] to select "ENGLISH".
Press [SET-UP] to remove the main menu.
• With regard only to the digital channel, even after the scan-
ning is complete if you unplug the AC power cord before
turning off the unit by pressing [STANDBY-ONy], the
channel setting may be lost.
Language Selection
You can choose English, Spanish, or French as your on-screen language.
1
Press [SET-UP] to display the main menu.
2
Use [Cursor K /L] to select "LANGUAGE",
then press [ENTER] repeatedly to change the setting.
or
3
Press [SET-UP] to exit.
e.g.) digital TV mode
--- TV SETUP ---
CHANNEL SETUP
V-CHIP SETUP
LANGUAGE
[ENGLISH]
CAPTION
[OFF]
DTV SETUP
[ENGLISH]
[ESPAÑOL]
[FRANÇAIS]
Publicidad
