Descargar Imprimir esta página

Philips AZ 1065 Manual De Instrucciones página 13

Ocultar thumbs Ver también para AZ 1065:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
PROBLEM
– POSSIBLE CAUSE
• REMEDY
No sound/power
– VOLUME not adjusted
• Adjust the VOLUME
– Headphones connected
• Disconnect headphones
– Mains lead not securely connected
• Connect the mains lead properly
– Batteries exhausted/ incorrectly inserted
• Insert (fresh) batteries correctly
Severe radio hum or noise
– Electrical interference: set too close to TV,
VCR or computer
• Increase the distance
Poor radio reception
– Weak radio signal
• FM: Direct the FM telescopic aerial for
optimum reception
• MW (AM) or LW: Direct the aerial by turning
the whole set.
or
– No CD inserted
• Insert a CD
– CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
– Laser lens steamed up
• Wait until lens has cleared
This product complies with the radio interference requirements of the European Union.
The type plate is located on the bottom of the set.
All manuals and user guides at all-guides.com
– CD-R(W) is blank or the disc is not finalised
• Use a finalised CD-R(W)
– CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
The CD skips tracks
– CD is damaged or dirty
• Replace or clean the CD
– SHUFFLE or PROGRAM is active
• Quit SHUFFLE/PROGRAM mode(s)
Poor cassette sound quality
– Dust and dirt on the heads, etc.
• Clean deck parts etc., see Maintenance
– Use of incompatible cassette types (METAL
• Only use NORMAL (IEC I) for recording.
Recording does not work
– Cassette tab(s) may be broken
• Apply a piece of adhesive tape over the
Remote control does not function properly
– Batteries exhausted/ incorrectly inserted
indication
• Insert (fresh) batteries correctly
– Distance/ angle between the set too large
• Reduce the distance/ angle
TROUBLESHOOTING
indication
or CHROME).
missing tab space.
13

Publicidad

loading