Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Insert a baluster into each baluster hole of
the bottom rail. Each kit contains 4 to 6
tabbed balusters (Fig. 9); space them evenly
throughout each section.
Set the top rail in place by inserting the
first baluster (at the upper post) into the
corresponding baluster hole of the top rail,
and work toward the bottom (Fig. 10).
Tabbed baluster
6.
Slide a bracket onto each end of the top rail as
shown pointing toward the rail ends (Fig. 11).
Check for proper fit and attach to the
mounting surface using the appropriate
mounting hardware (see step 3) for your
application (Fig. 12).
Pre-drill using a
1
/
8
supplied rail set screw through the side of
each bracket to secure the rail in place
(Fig. 13).
(Fig. 9)
(Fig. 10)
" drill bit and install a
(Fig. 11)
(Fig. 12)
(Fig. 13)
7.
Insert button caps (E) over set screws (C)
and snap the bracket plugs (D) in place.
(Fig. 14). If using a Titan steel post, snap trim
rings around bottom flange of support post.
Attach post cap, sold separately, using vinyl
adhesive.
(Fig. 14)
9
9
Publicidad
