Descargar Imprimir esta página

Samsung DMT610 Serie Guia De Instalacion página 21

Ocultar thumbs Ver también para DMT610 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

STEP 12 COMPLETING THE INSTALLATION
1. Open the door and remove all foam, paper packaging, and unnecessary parts.
2. Turn on the circuit breaker you turned off before you began the installation.
3. Open the water supply valve to supply water to the dishwasher.
4. Turn on the dishwasher, and then select and run a cycle.
Check if the power turns on correctly and if there is any water leakage while the dishwasher
is operating. If no errors occur while it is operating, turn off the dishwasher, and then go to
Step 5 below.
If an error has occurred, turn off the dishwasher, close the water supply valve, and then
refer to the user manual or contact a service center 1-800-SAMSUNG (726-7864).
Make sure to check for water leakage on both ends of the water supply line and drain hose
connector.
CAUTION
5. Confi rm that the kick plate gasket is on the bottom of the kick plate. To install the kick plate,
refer to the fi gure below.
installation_DD68-00046A-05_EN.indd Sec3:21
installation_DD68-00046A-05_EN.indd Sec3:21
All manuals and user guides at all-guides.com
installing the dishwasher _21
2011-12-28
2011-12-28
4:27:27
4:27:27

Publicidad

loading