Publicidad
Idiomas disponibles
Idiomas disponibles
while in brightness mode, then the light will reset to M1 mode the next night. If
the battery is not depleted, then the light will resume at the previous brightness
selected from the night before.
Timer Mode
To activate the light in timer mode for 1-8 hours and override the motion
detection modes (M1 or M2), select a brightness % button and then one of the
timer buttons (T1-T4). There is a switch located in the battery compartment of the
remote that toggles the T1-T4 buttons from 1-2-3-4 hours to 5-6-7-8 hours.
*Switch
position
in battery
Hours
Button
compartment
1
T1
OFF
2
T2
OFF
3
T3
OFF
4
T4
OFF
5
T1*
ON*
6
T2*
ON*
7
T3*
ON*
8
T4*
ON*
EXAMPLES
•
For 100% brightness for 4 hours, press the 100% button and then the T4
button (with the toggle switch set to OFF).
•
For 30% brightness for 5 hours, press the 30% button and then the T1
button (with the toggle switch set to ON).
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
User's Manual—Read before using this equipment
©2019 Wagan Corporation. All Rights Reserved.
Remote Switch
8
Publicidad
