Medistrom Pilot 24 Lite Manual Del Producto página 11

STEP 1 – Connecting Pilot-24 Lite to AC Power Adapter
STEP 2 – Connecting Pilot-24 Lite to PAP Device
Stand-by Mode
If the PAP device has been connected but not used within 10 min (or the PAP device is
turned off for 10 min), the Pilot-24 Lite will go into Stand-by Mode to conserve power.
To wake the Pilot-24 Lite press the Multi Function Button.
Charging Pilot-24 Lite
Follow STEP 1 above. Charge times for the Pilot-24 Lite via the ResMed AirSense 10, S9,
the Löwenstein prismaSMART or the Medistrom Pilot Lite AC adapter is approximately
2-3 hours. Charge time via the ResMed AirMini AC adapter is approximately 7-9 hours.
Plug the original ResMed AirSense 10 AC
power adapter into the Charge Port of the
Pilot-24 Lite and plug the other end into the
power outlet.
NOTE: Please use the Short Charging
Adapter Cable for ResMed AirMini or the
Löwenstein prismaSMART (included with
Pilot-24 Lite) to plug the original ResMed
AirMini AC power adapter into the Charge
Port of the Pilot-24 Lite and the Löwenstein
prismaSMART respectively.
Plug the L-shaped yellow tipped end of
the DC Out Cable for ResMed AirSense 10
Series into the DC Out Port of your Pilot-24
Lite and plug the other black tipped circular
end into the power connector port of your
AirSense 10 PAP device.
Once the Pilot-24 Lite is connected to your
PAP device, the Charge Level Indicator
Lights will turn on briefly and then the On
Indicator Light will turn solid blue. At this
point your PAP device will show that it is
receiving power. If your PAP device is not
receiving power, please check the cable
connections and press the Multi Function
Button.
11