Hotpoint Ariston PH 760 RF GH/HA Instrucciones De Uso página 19

Start-up and use
! The position of the corresponding gas burner or
electric hotplate* is shown on every knob.
Gas burners
Each burner can be adjusted to one of the following
settings using the corresponding control knob:
• Off
Maximum
Minimum
To light one of the burners, hold a lit match or lighter
near the burner and, at the same time, press down
and turn the corresponding knob anti-clockwise to the
maximum setting.
Since the burner is fitted with a safety device, the
knob should be pressed for approximately 2-3
seconds to allow the automatic device keeping the
flame alight to heat up.
When using models with an ignition button, light the
desired burner pressing down the corresponding
knob as far as possible and turning it anticlockwise
towards the maximum setting.
! If a flame is accidentally extinguished, turn off the
control knob and wait for at least 1 minute before
trying to relight it.
To switch off the burner, turn the knob in a clockwise
direction until it stops (when reaches the "•" position).
The "separate double flame" burner*
This burner consists of two concentric burners which
can operate either together or separately.
Use of the double flame on the maximum setting gives
a very high power which reduces cooking times with
respect to conventional burners.
Moreover the double flame crown provides a more
uniform distribution of heat on the bottom of the pan,
when using both burners on minimum.
To ensure that the double-flame burner is used to its To ensure that the double-flame burner is used to its To ensure that the double-flame burner is used to its To ensure that the double-flame burner is used to its To ensure that the double-flame burner is used to its
full potential, never set the inside ring to minimum and full potential, never set the inside ring to minimum and full potential, never set the inside ring to minimum and full potential, never set the inside ring to minimum and full potential, never set the inside ring to minimum and
the outside ring to maximum at the same time. the outside ring to maximum at the same time. the outside ring to maximum at the same time. the outside ring to maximum at the same time. the outside ring to maximum at the same time.
Pots and pans of all sizes can be used. In the case of
the smaller pots and pans we recommend the use of
only the internal burner.
There is a separate control knob for each of the
"separate double flame" burners.
The knob marked by the symbol
external burner;
The knob marked by the symbol
internal burner.
To turn on one of the rings, press the relative knob in
all the way and turn it anti-clockwise to the high
setting
igniter that automatically starts when the knob is
pressed in.
Since the burner is equipped with a safety device, Since the burner is equipped with a safety device, Since the burner is equipped with a safety device, Since the burner is equipped with a safety device, Since the burner is equipped with a safety device,
after lighting the burner keep the knob pressed in for
about 2-3 seconds to allow the device which keeps
the flame lit automatically to heat up.
The selected burner can be regulated using the
corresponding knob, as follows:
•
To switch off the burner, turn the knob in a clockwise
direction until it stops (when reaches the "•" position).
Ceramic Glass Module*
This cooktop is fitted with dual-ring radiant heating
elements located beneath the glass. It is possible to
turn on only the circular part of the elemement
(identified by the letter "A A A A A ") or the cooking surface can
be enlarged by turning on both "A A A A A " and "B B B B B ". To turn
only the circular "A A A A A " element, simply turn the knob in
the clockwise direction to any one of the 12 available
settings. To add the "B" section, turn the knob to
setting 12 and then click it into the
proceed by turning the knob in the counter-clockwise
direction to one of the 12 settings.
The figure shows the heating
zones, which become red when
the element is turned on.
A. Circular heating zone;
B. Extended heating zone;
C. Indicator light to show when
When the knob is on any of the settings other than
"Off", the Indicator Light for Ceramic Glass Module
comes on.
Practical advice on using the burners
To ensure the burners operate efficiently:
operates the
• Use appropriate cookware for each burner (see
operates the
*
. The burner is fitted with an electronic
Off
Maximum
Minimum
the cooking zone is above
60°C, even after the heating
element has been turned off.
table) so that the flames do not extend beyond the
bottom of the cookware.
Only available on certain models.
GB
setting. Then
B
A
C
19