Philips AVENT SCD833 Manual Del Usuario página 22

22
English
Disposal of your old product and battery
Environmental information
Remove the integrated battery
Your product is designed and manufactured with high quality materials and
components, which can be recycled and reused.
This symbol on a product means that the product is covered by European
Directive 2012/19/EU.
This symbol means that the product contains a built-in rechargeable battery
covered by European Directive 2013/56/EU which cannot be disposed
of with normal household waste. We strongly advise you to take your
product to an official collection point or a Philips service center to have a
professional remove the rechargeable battery. Inform yourself about the
local separate collection system for electrical and electronic products and
rechargeable batteries. Follow local rules and never dispose of the product
and rechargeable batteries with normal household waste.
Correct disposal of old products and rechargeable batteries helps prevent
negative consequences for the environment and human health. If there is
no collection/recycling system for electronic products in your country, you
can protect the environment by removing and recycling the battery before
disposing the headphones.
Make sure the headset is disconnected from the charging case before
removing the battery.
All unnecessary packaging has been omitted. We have tried to make
the packaging easy to separate into two materials: cardboard (box and
polyethylene (bags, protective foam sheet).
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
Note: We strongly advise you to have a professional remove the
rechargeable battery.
Only remove the rechargeable battery when you discard the appliance.
Make sure the battery is completely empty when you remove it. Only the
parent unit includes a battery.
Procedure:
1 Remove the 2 rubber feet at the bottom of the parent unit.
2 Remove the 2 screws that are now visible at the bottom of the parent
unit.
3 Put the antenna in upward position and remove the screw in the back
housing that is now visible.
4 Remove the back housing from the front housing by forcing a screwdriver
in between them. For newer versions manufactured after August 2020*,
there are 2 more screws underneath the rating label. Tear out the rating
label, remove the screws, release the belt clip and slide open the battery
compartment door.
5 Disconnect the battery connector cable (black-white-red cable).
6 Remove the 4 screws from the battery holder. No screws for new versions
manufactured after August 2020.
7 Remove the battery.